Before Starting Installation
1. Carefully read all warnings and instructions completely before beginning.
2. Verify all parts have been received in this kit by checking the parts list at the end of this document.
3. Only install this kit on the vehicle for which it is specified. If anytime during the installation you encounter something different from what is outlined in the instructions, call technical support at (928) 636-3176.
4. Special tools needed:
a. 17/64” drill bit
5. Park vehicle on a clean, dry, flat, level surface and block tires so vehicle cannot roll in either direction.
NOTE
Kit parts are prefaced by the word kit and appear in bold print.
NOTE
If parts are missing from kit, please be prepared to provide the following information:
1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
5. Inspector # from inside box cover
Prepare to Install Kit
Drivers Side of Vehicle
1. Install kit brackets (body mounted).
a. If equipped with factory steps remove and note hole locations as ORF Pro-Steps will mount in same location.
b. If not equipped with factory steps, locate Mounting holes on underside of body as shown below. Two holes on lower lip of body mount may have J-Nuts clipped in them. If there, remove J-Nuts from body.
0 comments for this entry ↓
There are no comments yet for this entry.
You must log in to post a comment.