Module Installation
1. The Power Edge EZ Module can mount on the flat black plastic fuse box cover located on the driver’s side fender. Adhere the module using the supplied velcro, allowing enough harness movement for removal of the cover.
ICP Sensor Connection
2. Connect the supplied ICP sensor wiring harness to the supplied main wiring harness in the engine compartment. Disconnect the stock wiring harness at the sensor located above the valve cover on the driver’s side towards the front of the engine. Plug the supplied ICP sensor connector into the stock ICP sensor on the engine and the stock engine wiring harness connector into the supplied ICP sensor connector.
NOTE: The ICP connector is on the drivers side of the engine located close to the engine removal ring under the boost hose – Notice the BLUE gasket. The ICP connector is NOT located at the front of the engine, as that is a coolant sensor!
Final Inspection and Operation
1. Recheck all connections, fittings and fasteners for a properly secure installation.
2. Using the supplied wire ties, secure the wiring harness from possible damage.
Fueling Adjustment
The Power Edge EZ Module features 4 different levels of fueling. The EZ Module is set default to level 2.
1. To change settings remove the front panel by using a 3/32” allen wrench to remove the two screws.
2. Below the cover the 3 jumper settings on the right side are used for the power level adjustment.
3. The two jumpers can be repositioned in any of the locations shown below to achieve the desired response.
0 comments for this entry ↓
There are no comments yet for this entry.
You must log in to post a comment.