PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS Pro.Fit MOUNT. All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break
STEP 1.
Begin by removing trim bezel that surrounds climate control. Insert hook tool in upper right corner of bezel, hooking tool behind bezel, and pulling towards you . Use hook tool on all four corners of bezel to release four (4) clips, two (2) on the top of bezel and two (2) on bottom of bezel. Let bezel hang. (HINT) Clips are very tight so pull firmly.
STEP 2.
Using Phillips screwdriver, remove factory screw on left side of climate control. Attach hang-up cup onto Pro.Fit mount.
STEP 3.
Position Pro.Fit mount over screw hole. Replace and tighten factory screw. With drill and 5/64” drill bit, drill starter hole using Pro.Fit mount as a guide. Insert provided screw and tighten with Phillips screwdriver. Reassemble trim bezel.
This completes the installation of your Pro.Fit mount.
0 comments for this entry ↓
There are no comments yet for this entry.
You must log in to post a comment.