Automotive Manual, Car Parts and News

STEP 1. Open up the power outlet door and locate and remove one (1) Phillips head screw using your # 2 Phillips screwdriver . Set screw aside. Open up both the cup holder door and the ashtray door. Remove the dash trim bezel that surrounds the radio and climate control and extends across the instrument cluster. To do this, grasp the bezel with your hands on the bottom right side of bezel just above the cup holder door pulling toward you to release a series of clips. Once released, work the remaining clips loose by pulling toward you all the way around the bezel. There are a total of fourteen (14) clips. When the bezel is loose disconnect the wiring harness to the power outlet and set bezel aside.
STEP 2. Using a 10mm socket & driver locate one (1) screw below and to the left of the radio holding the radio in place. Remove that screw and set it aside. Pull that corner of the radio out just far enough to slide the Pro.Fit mount behind the radio mounting bracket. Align the slot in the Pro.Fit mount with the screw hole and slide the radio back into place. Insert the factory screw and tighten with 10mm socket & driver.
STEP 3. Using the remaining holes in the Pro.Fit mount as a guide, drill two pilot holes using a 5/64” drill bit and drill. Insert the two (2) screws provided and tighten with # 2 Phillips screw-driver.
STEP 4. Re-assemble dash in reverse order and install hang up cup onto Pro.Fit mount.
This completes the installation of your Pro.Fit mount.

Download