Thank you for purchasing the Ford 7.3L Juice Module for the Ford Powerstroke Dieselо. The Juice module has been developed and produced from the highest quality materials available to ensure the best performance for years to come.
Please read these instructions through completely and thoroughly understand each step prior to installation. Warning: This product will not work on E-Series Vans, as some of the connectors are different from the F-Series pickups for which this product was designed for.
The Ford 7.3L Juice Module
The picture below shows the Ford 7.3L Juice Module for the Ford 7.3L engine with all available options – Both the Attitude™ display monitor and the three position switch. It is essential that the cables that are supplied with this module get connected as shown on the following pages.
Harness Connector
Your Juice module may be equipped with a harness that can be disconnected at the Juice module itself (See figure 1A). It is important to make sure that your juice module is always connected to the harness when the wiring harness is connected to the truck, otherwise the truck may not run properly, or may trip engine “codes.”
Engine Codes
As with many aftermarket electronic performance modifications available for the Ford 7.3L Power Strokeо Diesel engine the Ford 7.3L Edge Products Juice module for the Ford 7.3 Power Strokeо Diesel engine will likely set engine “codes.”
The engine codes are generally set during heavy acceleration. Although the codes will remain “set” in the PCM, the dash board indicator light should turn off within 15 minutes. Most codes that are set under hard acceleration are called “soft codes”. These soft codes are retained in the PCM and can be erased by unhooking the battery for 30 minutes, or by using the Edge
Products Evolution to clear the codes.
Codes that may be set:
• P1211 – Injector control pressure is different than expected
• P1209 – Peak injection pressure fault
The Ford 7.3L Juice Module modifies sensor readings that are monitored by the ECM. These sensor inputs may or may not be what the ECM is expecting at any point in time. Because of the difference in expected readings the ECM may set the engine codes. This is not expected to harm the Ford 7.3L engine and should not cause damage to the engine.
Stacking
This product is designed to be “stacked” with other products. Edge Products has designed this product to take advantage of other performance products and to reduce the fuel to the engine if the Exhaust Gas Temperature gets too high. This feature has been optimized to work best with the Evolution programmer from Edge Products.
0 comments for this entry ↓
There are no comments yet for this entry.
You must log in to post a comment.