THIS SYSTEM SHOULD ONLY BE INSTALLED BY A PROFESSIONAL MECHANIC. 2. Compare all contents of the boxes to the parts list before starting to insure all components are included. 3. Prior to installing the suspension system, inspect the vehicle’s suspension components, alignment, and frame for damage, corrosion, or cracks. Correct any worn or damaged parts before beginning install. 4. Always wear safety glasses during installation 5. On most vehicles, removal of the front bumper may be necessary in order to remove front spring eye bolts. 6. Install all nuts and bolts with a flat washer on both sides. 7. Unless otherwise noted, tighten all bolts to the torque specifications listed in the Torque Specification table included in these instructions. Use a torque wrench. 8. Estimated time to install this system is 6 hours. 9. Suspension components that use rubber or urethane bushings should be tightened with the vehicle at normal ride height. This will prevent premature failure of the bushing and maintain ride comfort 10. Check off the step number at the beginning of each step when you finish it. Then when you stop during the installation, it will be easier to find where you need to continue from.
1999-2004 Ford 4WD Super Duty 4″ Suspension System
July 6th, 2010 · No Comments
Related Tags: 4wd, alignment, boxes, corrosion, cracks, eye bolts, flat washer, Ford, front bumper, nuts and bolts, premature failure, professional mechanic, safety glasses, suspension components, suspension system, torque, torque specification, torque specifications, torque wrench, urethane bushings