Installation Instructions: Solid Bench Seat
Step One: Tilt the back of the rear seat forward. Remove jack handles from current plastic tray (if applicable). Using an 8mm socket remove bolts holding current plastic tray. Remove tray from truck. If you experience problems removing bolts you may need to apply upward pressure from under tray.
Step Two: Set the DU-HA in truck with DU-HA lettering facing forward. Secure DU-HA in truck using existing hardware.
Step Three: If desired install organizer/gun rack’s by snapping them into the slots in the DU-HA (as shown). Gun rack’s can be installed to hold two guns or one gun depending on how you install them. If you removed your jack handles from the existing tray you can place jack handles in DU-HA or on floor in front of DU-HA.
Safety Instructions:
Warning: Seat back must be up and latched at all times when vehicle is moving.
Make sure DU-HA is secured in the vehicle according to installation instructions.
Do not store explosives or hazardous materials in DU-HA.
Do not place loaded guns in the DU-HA.
For further instructions refer to truck owners manual or contact DU-HA.
Installation Instructions: 60/40 Split Bench Seat
Step One: Tilt the backs of the rear seat forward. On the drivers side remove the plastic cover by the seat bottom tilt lever using a Phillips screw driver. Next remove the plastic cover covering the side rear portion of the seat (be careful not to break spring clips when removing). Remove the two bolts holding the seat back using a 13mm socket.
Step Two: Remove jack handles from current plastic tray (if applicable). Using an 8mm socket remove bolts holding current plastic tray. Remove tray from truck. If you experience problems removing bolts you may need to apply upward pressure from under the tray.
Step Three: Remove Jack.
Step Four: Set the DU-HA in truck with DU-HA lettering facing forward. Pull seat back forward in order to get the DU-HA behind the seat.
Step Five: Secure the DU-HA in truck using existing hardware (as shown). Do not over tighten bolts.
Step Six: Re-attach seat back in the same manner as removed using existing bolts and a 13mm socket. Re-attach plastic covers. Snap rear cover back into same holes and secure front cover with the Phillips screw.
Step Seven: If desired Install organizer / gun rack’s by snapping them into the slots in the DU-HA (as shown). Gun rack’s can be installed to hold two guns or one gun depending on how you install them. If you removed your jack handles from the existing tray you can place jack handles in the DU-HA or on floor in front of the DU-HA
0 comments for this entry ↓
There are no comments yet for this entry.
You must log in to post a comment.