Automotive Manual, Car Parts and News

Step 1. Driver and Passenger Bottoms/DB&PB: The parts of the seat cover are labeled inside. Use the “Seat Cover Piece Identification Chart” to identify the parts. Temporarily remove the screw from the recline lever using a Phillips screwdriver.
Step 2. Driver and Passenger Bottoms/DB&PB: Slide the seat cover over the upholstered flap on the outside, then position the cut outs for the electric seat controls and recline lever. Electric controls only: Tuck the seat cover behind the electric control panel. Pull the outside edge of the seat cover back lining up the hole for the recline lever and mate the hook (sticky) fastener to the carpet on the back of the seat.
Step 3. Driver and Passenger Bottoms/DB&PB: Route the long hook fasteners under the front of the seat and mate them to the carpet on the back edge of the seat. Next, pull the inside edge of the seat cover (next to the center console) around to the back and fasten it to the carpet on the back edge.
Step 4. Driver and Passenger Bottoms/DB&PB: Route the long inside and outside hook fasteners to the carpet on the back edge. Tuck the back edge of the seat cover into the seat and mate the hook fastener sewn inside to the carpet on the back of the seat. Adjust the fasteners to re-position and smooth out any wrinkles. Move the seat in all directions after installing to make sure the seat’s action is not impeded.
Step 5. Driver and Passenger Tops/DT&PT: Temporarily remove the headrests by depressing the push button release and gently lifting up. Slide the seat cover on with the extending hook straps to the front. Tuck the seat cover under the plastic for the headrest starting with the push button release.
Step 6. Driver and Passenger Tops/DT&PT: Tuck the hook straps into the seat. Line up the seams of the seat cover to the seams of your seat, they should closely match. Gently pull on the hook strap with one hand from the back while sliding your other hand down the front of the seat cover taking up the slack in the seat cover. Lastly, mate the hook fastener to the loop fastener sewn inside the back edge.
Step 7. Console/C: With the console in the up position, slide the console cover on and tuck it in on the bottom. Fold the console down, holding it in position with one hand. Note where the fasteners will lay inside the cavity. Fasten the right side and left side rear hook tabs to the carpet behind the console hinge.
Step 8. Console/C: Clean the surface of the plastic with rubbing alcohol. Scrub the plastic hard with rubbing alcohol and wipe it dry when it’s still wet. Peel off the backing and stick the adhesive fasteners to the plastic on the inside of the box, not on the top. If they are not sticking, stop and re-clean the areas.
Step 9. Lid/L: Mate the fasteners under the console lid starting with the top or front. The small rear fasteners slide into the hinge in back or bottom. Reposition the straps for the proper fit.
Step 10. Console Lid/L: Mate the lid and the console cover in back. Note there will be a ―”-1” gap in the fabrics with a little loop fastener showing.

Download