KIT FEATURES
• DIN Mount Radio Provision with Pocket
• ISO Mount Radio Provision with Pocket
• Bonus Display Replacement Pocket
• Retains Factory Display For Automatic
Climate Controls
A) Radio Housing • B) ISO Brackets • C) Trim Plate • D) Display Replacement Pocket • E) Display Retention Brackets • F) (2) 3/8” #10 Bolts and (2) #10 Nuts.
1. Disconnect the negative battery terminal to prevent an accidental short circuit.
2. Unclip and remove display trim panel above radio. Tip: Open glove box and start in middle of panel working towards drivers side first because last connection on far passenger side is a hook. (Figure A)
3. Remove (2) Phillips screws exposed at top of radio then unclip and remove radio. Note: Display is attached to radio brackets and will be removed at same time as radio. (Figure B)
4. Remove (2) Phillips screws on back of display trim panel securing display trim then unclip and remove.
DISPLAY BRACKETS/POCKET ASSEMBLY MAZDA 3 2004-2008
1. Using the (2) 3/8” #10 bolts and (2) #10 nuts attach the display retention brackets to the display unit.
2. Remove the (2) Phillips screws in the sub dash. (Figure A)
3. Secure the display unit into the sub dash using the screws removed in the previous step.
0 comments for this entry ↓
There are no comments yet for this entry.
You must log in to post a comment.