Automotive Manual, Car Parts and News

Installation of the AEM Short Ram Intake System.
a) When installing the Short Ram Intake System, DO NOT completely tighten the hose clamps or mounting tab hardware until instructed to do so later in these instructions.
b. Install the supplied 1.75” to 2.25” reducing elbow onto turbo inlet with pipe and clamps as shown.
c. Assemble the supplied MAF bracket onto the MAF sensor as shown with the 2 M6 x 10 bolts removed in step 2L of disassembly. Install supplied 2.25” to 2.75” reducing coupler with clamps onto MAF sensor as shown. Note: Direction of MAF sensor!
d. Install the supplied M6 rubber mount into the threaded hole shown.
e. Install the MAF assembly from step 3C onto inlet pipe. The MAF bracket will install on to the rubber mount using the supplied M6 Nylok nut. Re-connect the MAF wiring harness to the MAF Adapter assembly.
f. Cut electrical tape holding MAF wires to harness to give it extra length. Take care not to cut the wires. Slit loom
g. Remove the electrical tape as shown.
h. Install supplied slit loom to MAF wires as shown.

Download