Automotive Manual, Car Parts and News

Removing the stock air inlet system
a) Before removing any of the O.E. components, label each individual part so that no components become mixed up during the installation process.
b) Stock air system
c) Unplug the Inlet Air Temperature Sensor (IAT) from the stock resonator box
d) Remove the breather hose from the plastic tee (Vehicles equiped with plastic tee).
e) Remove the breather hose from the plastic connector (Vehicles equiped with plastic connector).
f) Remove the two resonator bolts.
g) Remove the airbox nut.
h) Slide the resonator off the throttle body
i) Gently pull the airbox out of the rubber grommets and remove the entire intake system from the engine bay..
j) Twist the IAT sensor from the resonator box.
k) Remove the rubber o-ring from the IAT sensor.
l) Remove the ground wire bolt on the side of the engine bay. Save for later use.
m) Remove one of the bolts on the fender. Save for later use.

Installing the AEM Cold Air Intake
a) When installing the AEM intake, DO NOT completely tighten the hose clamps or the mounting tab hardware until instructed to do so later in these instructions.
b) Gently insert the IAT sensor into the nipple on the side of the rubber reducer coupler.
c) Attach the rubber mount to the outside of the heat shield using the supplied washer and nut.

Download