Automotive Manual, Car Parts and News

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the mass air sensor electrical connection and unhook the harness from the air box.
3. Remove the two bolts shown, which secure the engine cover.
4. Lift firmly on the engine cover to dislodge it from the mounting grommets, and then remove the cover from the engine as shown.
5. Remove the two bolts shown which secure the stock intake tube to the engine.
6. Using pliers, loosen the spring clamp which secures the crank case vent hose to the valve cover and then remove the hose from the valve cover as shown.
7. Loosen the two hose clamps shown which secure the stock intake tube to the air box and to the throttle body.
8. Remove the intake tube from the vehicle as shown.
9. Remove the air box retaining bolt shown.
10. Pull firmly on the air box to dislodge it from the mounting grommets and remove it from the vehicle.
NOTE: K&N Engineering, Inc., recommends that customers do not discard factory air intake.
11. Remove the two air box mounting studs shown from the inner fender.
NOTE: FAILURE TO FOLLOW INSTALLATION INSTRUCTIONS AND NOT USING THE PROVIDED HARDWARE MAY DAMAGE THE INTAKE TUBE, THROTTLE BODY AND ENGINE.
12. Install “L” Bracket (#07805) onto the heat shield with the provided hardware.
13. Install both rubber mounted studs onto the heat shield with the provided hardware.
14. Install the edge trim onto the heat shield as shown.
NOTE: Some trimming of the edge trim may be necessary.
15. Install the provided rubber mounted studs onto the heat shield using the supplied hardware.
16. Attach the provided “C” bracket (070093) to the rubber mounted studs installed in the previous step using the provided hardware.
17. Remove the bolt, which secures the ground strap to the inner fender.
NOTE: This bolt will not be reused.
18. Install the heat shield assembly into the vehicle and secure with the provided hardware.
NOTE: Secure the ground strap removed in step #15 onto the lower heat shield mounting bracket.
19. Install the silicone hose (084055) onto the throttle body and secure with the provided hose clamp.
20. Remove the two screws, which secure the mass air sensor to the stock air box and then remove the mass air sensor from the air box.
21. Install the mass air sensor into the K&Nо intake tube and secure with the screws removed in step #20.
22. Install the K&Nо intake tube into the silicone hose at the throttle body and align with the tube mounting bracket installed in step #16. Secure with the provided hardware and hose clamp.
23. Attach the provided silicone crank case vent hose to the valve cover and K&Nо intake tube as shown.
24. Install the filter adapter into the air filter as shown and secure with the provided hose clamp.
25. Install the silicone hose (084052) onto the air filter as shown and secure with the provided hose clamp.
26. Install the air filter assembly onto the intake and secure with the provided hose clamp.
27. Reinstall the engine cover removed in step #4 and secure with the factory mounting bolts.
28. Reconnect the mass air sensor electrical connection.

Download