Follow carefully the instructions listed on these pages and use the template provided, do not over tighten bolts. Do not use silicone on any connections, use mastic. Ensure that safe work practices are followed when installing your Airflow Snorkel. Protective ear and eye wear should be worn at all times when using power tools.
It is highly recommended that installation is undertaken by a qualified mechanic or panel beater. Gibson RM Manufacturing will not be held responsible for any damage incurred through incorrect fitment of the templates and workmanship. It is the responsibility of the fitter to ensure that particular care is taken when assembling the Snorkel kit to the vehicle as it may cause damage to the windscreen and or electrical components. Safe work practices must be used at all times when undergoing installation. We guarantee Airflow Snorkel kits against manufacturing defects as long as proof of purchase can be established. All models produced by Airflow Snorkels are verified to suit right hand drive vehicles according to Australian specifications. Variations in vehicle specifications may occur in other markets.
List of tools and additional parts required
Masking tape, clear tape, black mastic, hammer, centre punch
Assorted screw drivers, sockets and spanners, hacksaw
76mm hole saw
Assorted drill set, wet / dry sand paper, ½ round file, Small square file,
Zinc rich primer
It may be necessary to acquire new fixings from Nissan to replace the inner guard fixings if they get damaged during their removal.
0 comments for this entry ↓
There are no comments yet for this entry.
You must log in to post a comment.