Automotive Manual, Car Parts and News

To Start the installation:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Unlock the red locking tab on the air temperature sensor electrical connection, then depress the locking lever and pull apart the temperature sensor electrical connection
3. Loosen the hose clamp that secures the intake tube to the throttle body and pull the intake tube off the throttle body.
4. Disconnect the crank case vent hose from the valve cover port as shown.
5. Loosen and remove the air box mounting bolt as shown.
6. Lift the complete intake and air filter assembly to remove it from the vehicle.
7. Assembly the tube-mounting bracket and saddle clamp as shown with the provided hardware.
8. Using the provided hardware, install the tube-mounting bracket onto the engine at the threaded hole in the cylinder head as shown.
9. Install the provided edge trim onto the heat shield as shown.
NOTE: Some trimming of the edge trim may be necessary.
10. Install the Filtercharger adapter onto
the heat shield with the provided hardware as shown.
NOTE: Be sure to use the rubber gaskets provided
11. Install the K&N Filtercharger onto the filter adapter as shown.
12. Install the silicone hose (08698) onto the filter adapter and secure with the provided hose clamp as shown.

Download