Automotive Manual, Car Parts and News

RSS Feed

Free PDF Download, Car Parts and Automotive News

2006 Honda CR-V EX Front Door Panel Installation

May 31st, 2010 · No Comments

Use the appropriate tool from the KTC trim tool set to avoid damage when prying components. 1. Using a trim tool, pry out the upper portion of the cover (A) to release the hooks (B), then remove the cover. 2. Remove the screws. 3. Driver’s door: Pull the inner handle (A) rearward and out half-way to release the power door lock switch bracket (B) from the door panel (C). 4. Passenger’s door: Pull the inner handle (A) halfway. 5. Driver’s door: Disconnect the power door lock switch connector (A). Disconnect the inner handle rod (B), then remove the inner handle (C). 6. Lower the glass fully. 7. Remove the screws from under the armrest. 8. Passenger’s door: Remove the switch panel (A). 1 Insert a flat-tip screwdriver wrapped with protective tape through a hole under the armrest, and push up the back of the panel to release the rear hook (B). 2 Pull out along the edge of the panel to release the hooks (C) and clip. 3 Disconnect the power window switch connector (D). 9. Remove the mirror mount cover (see step 2 on POWER MIRROR REPLACEMENT ). 10. Remove the door panel (A) with as little bending as possible to avoid creasing or breaking it. 1 Release the clip (B). 2 Release the clips (C) that hold the door panel with a commercially available trim pad remover (D).

Source

Related Post


Related Tags: , , , , , , , , , , , ,


0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.

?>