Installing Hardware
1. Open lift gate.
2. Locate the two mounting location as indicated by the arrows.
3. On driver’s side, position drilling template, align the edges and tape in place.
4. Using a punch, mark the location for drilling. Remove paper template, ensure the hole is punched through, flip over paper template and repeat on passenger side.
Note: Use a 5mm drill stop to prevent going through outside sheet metal.
5. Using a 3/16” drill bit, drill holes in both locations.
6. Vacuum metal shavings from the trunk floor.
7. Screw in T-anchors. Tighten snugly, but do not overtighten.
8. Make sure both T-anchors are orientated in the up-down position.
Installation Net
1. Install cargo net over T-anchors, ensuring the pull tab in the middle of the net is facing rearward.
2. Confirm completed assembly.
0 comments for this entry ↓
There are no comments yet for this entry.
You must log in to post a comment.