Automotive Manual, Car Parts and News

Dodge Caliber, Jeep Compass Subwoofer Installation
1. Lift up on the B pillar post cover and then pull it towards the center of the car to remove.
2. Using a panel removal tool gently pry up the threshold/kick panel along the bottom of the front and rear door openings to release fasteners and remove panel.
3. Find the black plastic fastener securing the driver’s side kick panel and unscrew it.
4. Pull backwards on the kick panel to remove it.
5. Pull the cover of the foot rest to snap it loose.
6. Using a 10mm nut driver remove the nut securing the base of the foot rest.
7. Pull the front edge of the carpet down past the accelerator pedal.
8. Find the small drain hose coming from the HVAC housing that penetrates the floor pan near the accelerator pedal and pull it inside the vehicle.
9. Locate the battery access cover under the hood and remove according to the instructions printed on top of the panel.
10. Disengage the metal fasteners on the air filter box cover and move the cover to one side out of the way. It is not necessary to disconnect any of the ducting connected to the cover.
11. Remove the air filter and set aside. Pull straight up on the air filter housing and remove it from the vehicle.
12. Using a 10mm nut driver loosen and remove the nut on the positive battery accessory lug.
13. Connect the ring terminal of the power harness to the lug and retighten the nut.
14. Route the wire toward the rubber grommet that had the HVAC drain hose coming through it next to where the steering column comes through the fire wall securing with wire ties where needed.

Download