1. Disconnect the negative battery terminal to prevent an accidental short circuit.
2. If equipped with center speaker: Unclip and remove the grille. Remove (4) Phillips screws securing the speaker. Unplug and remove the speaker. Unclip the panel above the radio including the a/c vents, then unplug hazard switch and remove.
3. Unclip the panel above the radio including the a/c vents, then unplug hazard switch and remove. Unclip the panel below the radio including the climate controls. Unplug climate controls and remove the panel. (Figure D)
4. Remove (4) Phillips screws securing the radio, unplug and remove radio.
DIN RADIO PROVISION WITH POCKET
1. Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs outward.
2. Slide the aftermarket radio into the cage until it snaps into place.
ISO MOUNT RADIO PROVISION WITH POCKET
1. Mount the ISO Brackets to the radio with the screws supplied with the radio.
2. Slide the radio into the radio housing until it snaps into place.
3. Snap the trim plate onto the front of the Radio Housing.
0 comments for this entry ↓
There are no comments yet for this entry.
You must log in to post a comment.