Automotive Manual, Car Parts and News

Specially designed adapters are used in conjunction with Universal Anchoring System (UAS) stands and Universal Measuring System (UMS) pinchweld stands when securing vehicles with horizontal pinchwelds and vertical jack tabs in the corners of their center sections. (All Honda / Accord / Acura vehicles excluding Odessey.) These adapters allow the positioning of vertical jack tabs […]

[Read more →]

The Honda/Acura Immobilizer anti-theft system uses a low-power transponder mounted in the head of the ignition key. When the vehicle is started, the Key Cylinder Module converts the transponder signal and sends a secure, coded signal to the Engine Control Module. If the signal to the Engine Control Module is correct, the vehicle will start.

[Read more →]

The Acura® manual is an air displacement micropipette line intended for the accurate, precise and easy pipetting. The single channel models cover volumes ranging from 0.1 µL to 10 mL. Available in eight models with 8 or 12 channels, the multichannels are perfectly adapted for a continuous microplate pipetting in the 0.5 to 350 µL […]

[Read more →]

1) Getting started
a) Make sure vehicle is parked on a level surface.
b) Set parking brake.
c) Disconnect negative battery terminal.
d) If engine has run within the past two hours let it cool down.

[Read more →]

Test procedure:
1. Ensure that the switchblade mechanism functions by pressing the chrome button at the top of the remote. The key blank should rotate or flip out of the remote housing. Pressing and holding the chrome button while rotating the key blank down re-inserts it back into the remote. The mechanism should work smoothly.

[Read more →]

The AEM Cold Air System is the result of extensive development on a wide variety of cars. Each system is engineered for the particular application. The AEM Cold Air System differs from all others in several ways. We take the inlet air from outside of the engine compartment where the inlet air is considerably cooler […]

[Read more →]

This damper is intended for racing applications. It meets SFI Specification #18-1 and is legal for all sanctioned racing. Note that this damper has one 4-groove Poly-V pulley which is underdriven compared to the stock pulley. See specific underdriven amounts at bottom right of this page.

[Read more →]

NOTE: FAILURE TO FOLLOW INSTALLATION INSTRUCTIONS AND NOT USING THE PROVIDED HARDWARE MAY DAMAGE THE INTAKE TUBE, THROTTLE BODY AND ENGINE.
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Unlatch the four air box lid retaining clips.
3. Lift the air box lid up; then, disconnect the stock intake tube from the air […]

[Read more →]

The JG Edelbrock short shifter uses a stock style distance pin riding on two DU self-lubricated bearings. ACCESSORIES & INSTALLATION ITEMS: Our billet shifter knob PN 4709 is the ultimate choice to complement your new JG Edelbrock shifter. The threads on this shifter (M10×1.5) are compatible with the stock or any stock replacement shifter knob.

[Read more →]

Application: Honda/Acura Civic, Integra, CR-V 2001-on.
KCA368 is designed to replace the rear upper control arm-outer bushes on both sides of the car, and provides camber adjustment range of +/-0.75 degrees. It is recommended on most standard cars, and critical on any lowered car. Incorrect camber settings reduce traction, increase tyre wear and are detrimental to […]

[Read more →]