The instructions below are developed for BMW vehicles and are not be compared to any other existing instructions for vehicles other than BMW. No methods other than those specified in this document are to be used for installation in BMW vehicles. Left and right are determined from driver’s seat.
Entries Tagged as 'BMW'
Sirius Magnet-Mount Low Profile Antenna Kit Installation Instructions
October 15th, 2009 · No Comments
3 Series Coupe/Sedan Sirius Satellite Roof Antenna Kit Installation Instructions
October 15th, 2009 · No Comments
These instructions were developed especially for BMW vehicles and are not to be compared to any existing instructions for vehicles other than BMW. No methods other than those specified in this document are to be used to install Sirius Satellite Roof Antennas.
E39 5 Series Sirius Connect Installation
October 15th, 2009 · No Comments
Before attempting to use your new Sirius Connect System, it is IMPERATIVE that you read the initialization guide at the end of this document. Not doing so will result in an inoperative Sirius module and will require you to take time out of your day to call our support line. If we aren’t open, or […]
2000–2004 BMW X5 SAV Tekonsha Prodigy Electric Trailer Brake Control Installing
October 14th, 2009 · No Comments
The 2000 – 2004 BMW X5 SAV is rated to tow up to 6,000 lbs GVW with the factory specified hitch. Trailers this large may often be equipped with, and/or require electric trailer brakes. The X5 is one of the most advanced Sport Utility vehicles offered and requires special care and attention when installing a […]
BMW X5 Electric Trailer Brake Controller Installation
October 14th, 2009 · No Comments
This is the outline of my installation of a Tekonsha Prodigy brake controller into a 2001 3.0 5sp X5.
I opted to install the Prodigy in the console ashtray. It’s in front of the shifter and relatively easy to reach the manual brake lever – it’s just a little tough to reach in 1st and 3rd […]
E46 bi-Xenon, Xenon and Halogen Installation Instructions
October 12th, 2009 · No Comments
The kit is very easy to install. But you must take your time. The rings, once installed, are durable enough to take the rigors of driving on the street. The mounting system and installation method ensure that the rings will resist vibration and jarring extremely well. That said, the rings are very susceptible to breakage […]
E46 VDO Gauges Installation
October 12th, 2009 · No Comments
Basic Installation Instructions
This is not an easy mod. Do not attempt it if you do not feel mechanically comfortable. If you make an error installing the senders, you could seriously damage your car and/or void your warranty. I will go into as much detail as possible in this write-up, but if you have questions after […]
BMW E46 M3 Sport Away Bar Set
October 12th, 2009 · No Comments
INSTALLATION OF HOTCHKIS FRONT SWAY BAR
1) Drive the front of the vehicle onto floor ramps and securely block the rear wheels of the vehicle. If ramps are not available, use a jack to lift up the front of the vehicle and use jack stands to support it. Do not remove the front wheels during installation […]
BMW E46 M3 2001- AA Short Shifter Instructions
October 12th, 2009 · No Comments
NOTE: If you have a lighted gearshift knob, do this first !!!
-At the base of the gear lever is a shift boot surrounding the lower shaft.
-Remove the shift boot by detaching the shift boot base from the console area, it is snapped in at the four sides.
-Locate the lighted knob wire that comes from the […]
BMW E46 M3 Running Gear and Suspension
October 11th, 2009 · No Comments
A requirement in the development of the running gear for the E46 M3 was: “The running gear must be faster than the engine”. The exceptional running gear and suspension of the E46/2 as well as the outstanding running gear of the M3 predecessor served as the basis for the E46 M3. The combination of a […]