Automotive Manual, Car Parts and News

PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS Pro.Fit MOUNT. All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break
STEP 1.
Begin by removing trim bezel that surrounds climate control. Insert hook […]

[Read more →]

The venerable Crown has been around since 1930~ The first model was the KM. It was 190 cubic inches and produced, by the standards then, seventy horsepower at 3200 RPM. Over the years that engine has evolved until about 1957, when it produced 135 horsepower and was referred to, as the “hot rod engine”. I […]

[Read more →]

To inform Chrysler vehicle owners about Chrysler Technical Service Bulletin TSB 09-05-00 (1). The Chrysler Bulletin describes the replacement of the engine intake manifold plenum pan gasket. If the ple- num gasket leaks, it may disrupt the performance and service life of the motor oil.
The Chrysler TSB 09-05-00 noted two symptoms of a plenum gasket […]

[Read more →]

Trenton Engine Plant (TEP) is Chrysler Corporation’s largest producer of Chrysler-made car and mini-van engines. Waste oil from machining operations at the plant is recovered at the facility’s wastewater treatment plant and shipped off-site for commercial recycling. When the costs of lost raw material as well as treatment and disposal were totaled, hydraulic oil leaks […]

[Read more →]

On some vehicles the MSD Crank Trigger Kit may require slight modifications to accomodate special engine plates, pulley systems, etc.
INSTALLING THE PICKUP AND BRACKET
1. Mount the pickup holder onto the bracket using the two fine thread bolts (Figure 1). The pickup base will only install one way, do not try to force the bolts in, […]

[Read more →]

When Fred Zeder, Owen Skelton and Carl Breer developed the original engine for the 1924 Chrysler, they selected a flat-head or valve-in-block design. Chrysler engineers continued to use this conservative design until the new Hemi V-8 in the 1951 Chrysler New Yorker.
In the late 1920s and early ’30s, other auto manufactures used various combustion chamber […]

[Read more →]

Crane’s adjustable rocker arms must be installed on NEW rocker shafts. Care must be taken to install the oil feed holes in the new shafts toward the cylinder head and toward the valve springs so that oil pressure gets to the side of the shaft which is heavily loaded. These rocker arms are installed in […]

[Read more →]

The following information refers to recommended engine oil for 2004- 2007 Chrysler engines. This information should be considered any time the engine oil is added or changed. The symbol shown in Figure 1, below, is found on the front of the container, and signifies the oil quality has been certified by the American Petroleum Institute […]

[Read more →]

PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with common tools and procedures. However, you should be familiar with and comfortable working on your vehicle. If you do not feel comfortable performing this installation, it is recommended to have the installation completed by a mechanic.
• MANIFOLD: The Torker 383 […]

[Read more →]