Automotive Manual, Car Parts and News

1. Before beginning the installation, please read the instructions thoroughly and verify that the hardware kit is complete. If any of the pieces listed above are missing, call you distributor immediately to obtain the necessary items.
2. Identify your product´s components. Tips: The front of the side bar has the step pad farther from the edge […]

[Read more →]

All hardware should be tightened only enough to ensure safety during assembly. Fully tighten all hardware after entire assembly is completed.
1. Remove the plastic air dam from the bottom of the front bumper. The air dam cannot be reinstalled when this mount kit is on the truck and should be returned to the vehicle owner […]

[Read more →]

The FP-RAM (1994-Newer Dodge Ram Truck base) is a no-holes base. The base consists of two main components: a base with an extension plate and a pole assembly. Installing a no-holes base does not require drilling any holes into the vehicle.
Attaching the extension plate:
1. Attach the extension plate to the bottom side of the base, […]

[Read more →]

Pillar installation Directions: Read directions before starting installation Model# (17212 Dual), (17213 Triple) Fits 03+ Dodge Ram
1)  Remove Stock Pillar by removing the two  screws located under the caps of pillar handle.
2)  Install Gauges in new pillar.
3)  Tape or secure gauge wiring to back of pillar.
4)  Install new pillar in place of old pillar.
5)  Use provided screw to hold pillar in place:
•  Make sure screw is aligned with factory hole to avoid cross threading
•  Don’t over tighten screw.

[Read more →]

For easier assembly and installation, vehicle and all snowplow components should be on a smooth, level, hard surface, such as concrete.
1. Remove license plate bracket and retain for vehicle owner. Remove bumper from bumper brackets. Retain fasteners.
2. Remove bumper brackets from frame. Retain fasteners.
Diesel applications: On these applications, you must first remove the top two […]

[Read more →]

1. Remove tailgate by disconnecting the tether cable and lifting the tailgate out at approximately a 45º angle. (Reference the truck’s Owner’s manual).
2. Carefully remove the OEM tailgate pivot cup from the tailgate taking note of which side they belong on.
3. Remove latch pin bolt. A special wrench may be required.
4. Figures 1 through 5 […]

[Read more →]

Removing the OEM seat
A. Begin by lifting the bottom cushion out from the rubber grommets in the floor (See fig. 6). Remove the seat belts by removing the OEM nuts from their mounting studs using a 18mm socket/wrench (See fig. 1). Do not remove the shoulder straps anchored at each side of the vehicle.
B. Remove […]

[Read more →]

Monkey Poo Dodge Ball Assembly Instructions
1. Select a level area to operate game with plenty of room to allow for a line to form.
2. Assemble framework, per sketch. Note that the eight longer pieces of tubing are used to form the sides (2 per side) while the four shorter crimped pieces are to be used […]

[Read more →]

Thank you for purchasing Figure’s 2005-Present Dodge Charger Grille set. These grilles are fabricated employing quality materials and finishes, and have been engineered to enhance the look of your vehicle for the duration of its life. Proper installation is essential to your overall satisfaction, so please read these instructions before attempting to install the grilles. […]

[Read more →]

The mounting procedure outlined below covers 1973 - 1993 Dodge W250 & W350 trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as follows:
1. Remove the Front Bumper and Front Bumper Mounting Brackets from the Frame Horns. […]

[Read more →]