Automotive Manual, Car Parts and News

1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the mass air sensor electrical connection.
3. Loosen the hose clamps on the intake hose at the throttle body and mass air sensor.
4. Using a 10mm socket, loosen and remove the bolt that holds the vacuum switch to the airbox lid.
5. Release the […]

[Read more →]

Installation of this baseplate requires removing the bumper.
1. Read the General Instruction Sheet included with this baseplate.
2. The baseplate mounts to the vehicle using the four bolts that mount the bumper to the frame and two bolts into the frame. All bolts are provided with the baseplate.
3. The bumper of the pickup will be removed […]

[Read more →]

PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. DO NOT ATTEMPT INSTALLATION ALONE; PERSONAL INJURY OR DAMAGE TO THE TRUCK MAY RESULT.
2. From underside of vehicle, remove the passenger and driver side splash shield and the air valance.
3. Measure and mark 12 ―” from the outside and […]

[Read more →]

Installation of the side strakes should taoe approximately 30 minutes per side to complete following these simple instructions. Allow yourself plenty of time. There is no need to rush and potentially make mistakes that could lead to additional work or worse, damage to your new strakes. Please read through these instructions entirely before beginning the […]

[Read more →]

The drop link is fully rose-jointed and is a direct replacement for the original unit. Instead of using rubber bushes to provide the articulation, it uses two rod ends to provide smoother movement — and an end to regular bush replacement. NOTE: the front and rear drop links are identical and these fitting instructions cover […]

[Read more →]

It is recommended that this set be professionally installed if you are unfamiliar with this type of work, and a factory service manual be purchased prior to performing any work on your vehicle for proper disassembly, reassembly and torque specs. These instructions are intended for bushing removal and install of Energy Suspension polyurethane bushings, once […]

[Read more →]

Powerchip technology enhances your Mazda to its ultimate level, delivering faster, smoother acceleration in all driving conditions. Whether you enjoy a leisurely weekend cruise or a hard racetrack drive – there is no easier and more effective way to release the potential from your Eunos 30X 1.8 V6. The following information is an overview of […]

[Read more →]

1. Unscrew the stock shift knob by rotating it counter clockwise.
2. Open the storage compartment in the center console and remove the foam rubber mat in the bottom to access the 2 bolts. Use an 8mm socket and ratchet with an extension to remove the 2 bolts.
3. Lift up on the rear half of the […]

[Read more →]

It is recommended that this set be professionally installed if you are unfamiliar with this type of work, and a factory service manual be purchased prior to performing any work on your vehicle for proper disassembly, reassembly and torque specs. These instructions are intended for bushing removal and install of Energy Suspension polyurethane bushings, once […]

[Read more →]

Track Dog Racing Exhaust Heat Shield, which is designed to help maintain lower temperatures in the engine compartment by isolating elevated header temperatures. The TDR Heat Shield will install on all model years of the Mazda Miata. Both factory exhaust manifolds and aftermarket headers will see the benefits of reduced heat transfer in the engine […]

[Read more →]