Automotive Manual, Car Parts and News

1. Layout all parts and check quantities against the Bill of Materials. Completely read instructions before beginning installation.
2. Jack the front of the vehicle in accordance to manufacturer recommendation and support with jack stands, so that the front two tires are off the ground
3. Remove the front tires/wheels.
4. Disconnect the steering linkage and push forward, […]

[Read more →]

This inlet pipe kit requires the removal and reinstallation of emissions related components. If you are not familiar with the installation and/or the operation of these components then please refer this installation to a qualified professional.
Installing the Short Ram Air Intake System
a) When installing the AEM Air Intake System, DO NOT completely tighten the hose […]

[Read more →]

By installing your Borla Performance Exhaust System, you indicate that you have read this document and you agree with the terms stated below. It is the responsibility of the purchaser to follow all installation instruction guidelines and safety procedures supplied with your Borla Performance Exhaust System
Borla Performance Industries assumes no responsibility for damages occurring from […]

[Read more →]

Most 17” wheels will clear the outer diameter of the caliper for a 328mm or 332mm rotor kit. For a 355mm kit, a minimum 18” wheel is typically required, and for a 380mm rotor kit, a minimum 19” wheel is needed. The more critical clearance, however, is the gap between the spokes of the wheel […]

[Read more →]

Read instructions before assembling. Fasteners should be finger tight until instructed to tighten according to the torque chart. Use standard methods and practices when attaching snowplow including proper personal protective safety equipment.
MOUNT INSTALLATION
1. If the vehicle is equipped with a stamped-steel splash guard and/or tow hooks, remove them. Retain the splash guard, tow hooks, and […]

[Read more →]

1. After the front lip spoiler is prepped and painted, double-sided tape should be applied to the indentation on the inside of the front spoiler. This surface has to be CLEAN and DRY for the tape to properly adhere. A residual-free cleaner is recommended (e.g. Wurth ™ Clean-Solve) to prepare the surface. The surface of […]

[Read more →]

If you are not familiar with the use of hand tools or not accustomed to working on motor vehicles, have a dealer or accessory shop install the X2000 Platinum Series EZ-Lift Lid. Carefully read all the instructions prior to attempting to fit the Lid. Before fitting the Lid, park the vehicle on level ground in […]

[Read more →]

Follow carefully the instructions listed on these pages and use the template provided, do not over tighten bolts. Do not use silicone on any connections, use mastic. Ensure that safe work practices are followed when installing your Airflow Snorkel. Protective ear and eye wear should be worn at all times when using power tools.

[Read more →]

Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely unroll and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your vehicle with a weight in each corner (a book works well). After […]

[Read more →]

1. Disconnect the negative battery terminal to prevent an accidental short circuit.
2. If equipped with center speaker: Unclip and remove the grille. Remove (4) Phillips screws securing the speaker. Unplug and remove the speaker. Unclip the panel above the radio including the a/c vents, then unplug hazard switch and remove.
3. Unclip the panel above the […]

[Read more →]