Automotive Manual, Car Parts and News

List of tools and additional parts required
Masking tape, clear tape, black mastic, hammer, centre punch
Assorted screw drivers, sockets and spanners 103mm (4”) hole saw
Assorted drill set, wet / dry sand paper, ½ round file, small square file, Zinc rich primer.

Detailed Instructions:
1 Prior starting any work, ensure that the configuration of the air box is as shown. If it is not, the fitting of this kit will not be possible. Contact your dealer for further assistance
2 Remove the splash panel
3 Disconnect and remove the top of the air box
4 Remove the air box from the engine bay
5 Remove the air intake and discard it.
6 Locate the connector SP184 as shown
7 Drill six 4mm holes in the connector SP184 (2 on the top, 2 on the bottom 1 on each side)
8 Please wear gloves
9 Use only NON SILICONE BASE back mastic
10 Smear some sealant on the connector SP184
11 Using the screws SP029, attach the SP184 to the air box
12 This is the way it will look once finished
13 Read the template carefully
14 Cut the template out along the guard line
15 Cut the antenna hole
16 Cut the internal tapping areas to allow sticking the template very close to the body of the car
17 Start tapping the template from the top left ensuring to follow the guard line carefully
18 Continue tapping in sequence ensuring that the template follow the contours of the guard
19 The template should be secure as shown above
20 Centre punch all marked holes
21 Remove the template
22 Cover the areas to be drilled with masking tape

Download