Automotive Manual, Car Parts and News

FRONT OF FRONTIER
1. Park vehicle on level concrete surface.
2. Center and lock the steering wheel.
3. Block the rear wheels of the vehicle to prevent vehicle from moving in either direction.
4. Jack up the vehicle from the lift point in Figure A.
5. Support the vehicle with jack stands from the points in Figure A.
6. Remove the [...]

[Read more →]

Haynes offers the best coverage for cars, trucks, vans, SUVs and motorcycles on the market today. Each manual contains easy to follow step-by-step instructions linked to hundreds of photographs and illustrations. Included in every manual: troubleshooting section to help identify specific problems; tips that give valuable short cuts to make the job easier and eliminate [...]

[Read more →]

Front Installation
2. Raise vehicle until front tires are clear, support the vehicle.
3. Remove the front tire and wheel assembly.
4. Remove the lower stabilizer link bolt and move sway-bar assembly out of way.
5. Remove the upper ball joint nut.
6. Separate the upper ball joint from the spindle.
7. Remove the strut assembly and install the strut spacer [...]

[Read more →]

FRONT OF XTERRA
1. Park vehicle on level concrete surface.
2. Center and lock the steering wheel.
3. Block the rear wheels of the vehicle to prevent vehicle from moving in either direction.
4. Jack up the vehicle from the lift point in Figure A.
5. Support the vehicle with jack stands from the points in Figure A.
6. Remove the [...]

[Read more →]

Before installing your Truxport system, install cab seal on the front bulkhead of your pickup bed.
STEP 1: Install cab seal inside front bulkhead, covering full width of bulkhead. Align top edge of seal flush with top edge of bulkhead. Slowly peel backing and press seal against bulkhead to bond adhesive.
STEP 2: Position cab header over [...]

[Read more →]

PowerAid throttle Body spacer instruction for Nissan Xterra/Frontier:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake assembly.
3. Remove (4) bolts from the throttle body. (Ref. “C”)
4. Remove gasket and clean surfaces.
5. Remove bolts from the throttle linkage bracket and save.

[Read more →]

This digital document is an article from Fleet Equipment, published by Maple Communications on August 1, 2004. The length of the article is 2152 words. The page length shown above is based on a typical 300-word page. The article is delivered in HTML format and is available in your Amazon.com Digital Locker immediately after purchase. [...]

[Read more →]

Proper installation of a TrailMaster body lift kit requires knowledge of the factory recommended procedures for disassembly and assembly of original equipment components. We recommend that the factory shop manual and any special tools necessary to your vehicle be on hand during the installation. Installation of this body lift kit without proper knowledge of the [...]

[Read more →]

Haynes manuals are written specifically for the do-it-yourselfer, yet are complete enough to be used by professional mechanics. Since 1960 Haynes has produced manuals written from hands-on experience based on a vehicle teardown with hundreds of photos and illustrations, making Haynes the world leader in automotive repair information.

[Read more →]

The intent of this guide is to provide information to help you respond to emergency situations involving the 2008 GMC Yukon & Chevrolet Tahoe Two-mode vehicles in as safe a manner as possible.
While the majority of the components that make up our Hybrids are common to traditional GM vehicles, there are some

[Read more →]