Automotive Manual, Car Parts and News

This version of the Attitude is only compatible with the Edge Ford 6.0 Juice module version 2.4 or later. If you have a prior version, an upgrade is necessary before the Attitude will connect to your Juice module.
The Attitude allows you to monitor the performance of your vehicle’s vital engine components and output values. The following parameters can be displayed on the main Attitude screen:
• Boost
• EGT (exhaust gas temperature)
• RPM
• Percent back down due to high EGT

One of the most powerful features of the Attitude is the option to monitor the EGT of your vehicle and automatically lower the power output to maintain an EGT below a maximum desired level. The Attitude will also alert you both visually and audibly at pre-set engine parameter thresholds and also record the maximum values reached in each of the parameters.

Get Connected:
The Attitude monitor connects under the hood to the Edge Juice module. Follow these steps to install the Attitude:
1. Place your Attitude monitor on the dash of your vehicle approximately where you want it installed and, with the driver’s door open, feed the cable through the open door, and into the engine compartment via the slot near the hood hinge.
2. Determine where you want to attach the Attitude mounting arm and, using the self adhesive tape on the mounting arm base, stick the mounting hardware to the back of the Attitude and to your vehicle’s dash area. Due to the adhesive tape’s inability to stick in extreme hot and cold conditions, two set screws are included with your Attitude mounting hardware to secure the mounting hardware to the dash of your vehicle. Desired mounting locations will vary widely.
3. Connect the Attitude to your Edge Juice module by snapping together the cables wih the green connections and connecting the map sensor (the little brown wire) to the map sensor connection. Secure any excess cable to prevent entanglement with moving engine parts.
4. It is necessary to tap a small hole into your exhaust manifold to insert the EGT sensor. Drill the hole using a 5/16” drill bit, then tap it with an 1/8” NPT tap. Once the hole is drilled and tapped, insert the EGT sensor by threading it into the hole. The photo below is taken viewing the truck from the ground up. The section of the exhaust manifold that requires tapping is located on the driver’s side above the driveline.

Download