Automotive Manual, Car Parts and News

RSS Feed

Free PDF Download, Car Parts and Automotive News

Honda VTX1300S/R Audio Attachment Kit Installation Instructions

October 16th, 2010 · No Comments

INSTALLATION NOTE: • Disconnect the negative cable from the battery before installing this accessory.
• Trim the excess ends off the wire ties after attaching them to the wire harnesses. Do not allow the cut part of the wire tie to interfere with another harness or brake hose.
• Be sure to observe all safety notes and precautions described in the Service Manual while removing and installing the fuel tank. Gasoline is extremely flammable and is explosive under certain conditions. Refuel in a well-ventilated area with the engine stopped. Do not smoke or allow flames or sparks in the area where gasoline is stored or where the fuel tank is refueled.
1. Refer to the Service Manual to remove the parts.
2. Remove the air cleaner cover and pull out the air cleaner case as shown.
3. Loosely install the speaker holder on the handlebar as shown.
4. Loosely install the speaker as shown.
5. Install the bracket on the amplifier unit as shown.
6. Install the amplifier unit as shown.
• Tighten the upper bolt first, then tighten the lower bolt.
7. Route the amplifier unit harness as shown.
8. Route the speaker harness and amplifier unit harness and connect them as shown.
9. Route the audio harness and connect it as shown.
10. Route each harness as shown. Install the headlight in the reverse order of removal.
• Refer to the illustration shown below and bundle the harness in the headlight case. Take care not to pinch the harness when installing the headlight.

Download

Related Post


Related Tags: , , , , , , , , , , , , , , , , , , ,


0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.

?>