Pre-Installation:
1. Remove all stock intercooler pipes and intercoolers (Refer to Factory Service Manual for removal instructions)
2. Install Front Mount Intercooler. (Refer to FMIC installation section)
3. Unbolt Oil Cooler and move forward at least one inch.
a. Remove upper bracket
b. Bolt lower hole to existing hole where factory intercooler was.
c. Mark hole for upper side bracket hole
d. Drill and tap whole and attach with a bolt and washer.
4. Unbolt bracket that attaches clutch vacuum pipe to fuse box in engine compartment. (by radiator overflow jar)
Installation:
6-speed cars may require additional modifications to clear the shifter counter weight. Moving the Radiator overflow tank will create more room and is recommended on 6-speed cars. Modifying or removing the counter weight on the tranny linkage will aid in install on 6-speed models. It is not mandatory but will make install a lot easier.
Front turbo pipe 1
a. Remove front turbo inlet hose
b. Remove upper radiator hose.
c. Unbolt radiator brackets (removing the radiator will aid install but is optional)
d. Install 1.5” hose on turbo outlet. (*use WD40 or some oil to aid installation, it is a tight fit)
0 comments for this entry ↓
There are no comments yet for this entry.
You must log in to post a comment.