Automotive Manual, Car Parts and News

RSS Feed

Free PDF Download, Car Parts and Automotive News

Nissan Titan Mount Kit Personal Plow Installation Instructions

November 25th, 2009 · No Comments

Read instructions before assembling. Fasteners should be finger tight until instructed to tighten according to the torque chart. Use standard methods and practices when attaching snowplow including proper personal protective safety equipment.

MOUNT INSTALLATION
1. If the vehicle is equipped with a stamped-steel splash guard and/or tow hooks, remove them. Retain the splash guard, tow hooks, and fasteners for reinstallation if the snowplow mount is removed. If the vehicle is equipped with a front skid plate, remove it and the adjoining support brackets and tow hooks. Retain the skid plate, support brackets, tow hooks, and fasteners for reinstallation if the snowplow mount is removed. Remove the license plate and connecting bracket assembly from the skid plate and reinstall it to the vehicle’s front bumper as located by the preexisting detents.
2. Position the mount against the bottom surfaces of the vehicle frame rails while aligning the front mount holes with the tow hook holes. Secure the mount to the frame rails with M12 x 1.25 cap screws and 1/2″ flat washers (supplied with the mount). Hand tighten only.
3. Clamp the rear of the mount against the bottom surfaces of the vehicle frame rails on both the driver and passenger sides.
4. Remove the bumper brace to gain access for drilling holes through the vehicle frame rails. Using the rear hole in the mount as a guide, drill a 17/32″ hole through the outside wall of the vehicle frame rail.
CAUTION
Read instructions before assembling. Fasteners should be finger tight until instructed to tighten according to the torque chart. Use standard methods and practices when attaching snowplow including proper personal protective safety equipment.
5. Place a 1/2″ flat washer onto a 1/2″ bolt with handle, and insert the bolt into the slot located on the bottom surface of the vehicle frame rail rearward of the mount. Pass the bolt out through the vehicle frame and mount holes, bending the handle as necessary. Place a 1/2″ locknut on the bolt, and hand tighten.

Download

Related Post


Related Tags: , , , , , , , , , , , , , , , , , , ,


0 comments for this entry ↓

  • There are no comments yet for this entry.

You must log in to post a comment.

?>