GM Pass-Key III (Easily identified by a ‘PK3’ stamped on the blade)
ORIGINATE A NEW KEY:
1. Insert new transponder key and turn ignition to ‘ON’ position. The dashboard security light will turn on and stay on for 10 minutes.
2. Once the security light goes out, you have one minute to to begin Step 3. Turn ignition to ‘OFF’ and then back to ‘ON’ position.
3. Repeat Step 2.
4. Once the dashboard security light has turned off for the third time, the key has been successfully programmed. This is now the only key that is programmed to the system and all previous electronic key codes have been erased.
ADD A DUPLICATE KEY:
1. Insert the newly programmed key and turn ignition to ‘ON’ position and then back to ‘OFF’.
2. Remove existing key, insert new transponder key and turn to ‘ON’ position. THIS MUST BE DONE WITHIN 15 SECONDS.
3. The dashboard security light will come on for two seconds indicating successful programming.
1997 Ford, Lincoln, Mercury - 1998 Ford, Mercury
ORIGINATE A NEW KEY:
1. Insert new transponder key and turn ignition to ‘ON’ position. The dashboard security light will turn on and flash for 15 minutes.
2. Once the security light stops flashing, you have five minutes to to begin Step 3. Turn ignition to ‘OFF’ and then back to ‘ON’ position. The dashboard security light will turn on and flash for another 15 minutes.
3. Repeat Step 2.
4. Once the dashboard security light has stopped flashing for the third time, the key has been successfully programmed. This is now the only key that is
programmed to the system and all previous electronic key codes have been erased.
ADD A DUPLICATE KEY:
1. Insert the newly programmed key and turn ignition to ‘ON’ position and then back to ‘OFF’.
2. Remove existing key, insert new transponder key and turn to ‘ON’ position. THIS MUST BE DONE WITHIN 15 SECONDS.
3. The dashboard security light will come on for two seconds indicating successful programming.
0 comments for this entry ↓
There are no comments yet for this entry.
You must log in to post a comment.