Automotive Manual, Car Parts and News

Make sure you park the vehicle on a level concrete or asphalt surface. Many times a vehicle is uneven (side-to-side) from the factory, but usually not noticed until a lift kit has been installed which makes the difference more visible. Using a measuring tape, measure the front and rear (both sides) from the ground up […]

[Read more →]

A correct installation must result in the suspension and axle being “loaded” within the range specified by axle and suspension manufacturers. Please check vehicle specifications and intended usage to insure axle will be within Gross Axle Weight Rating (GAWR). No alteration of any suspension component is permitted. Link Mfg. Is not responsible for damages from […]

[Read more →]

The Slide-A-Link by Competition Engineering is designed for use in 2 Wheel Drive Ford Lightning Pickups. The rigid front mount assembly clamps around the leaf spring creating a positive displacement point for torque transmitted from the rear axle through the unique sliding link, cushioned by the urethane shock pad. Free travel and pre-load adjustments […]

[Read more →]

GENERAL NOTES:
1. THIS SYSTEM SHOULD ONLY BE INSTALLED BY A PROFESSIONAL MECHANIC.
2. Compare all contents of the boxes to the parts list before starting to insure all components are included.
3. Prior to installing the suspension system, inspect the vehicle’s suspension components, alignment, and frame for damage, corrosion, or cracks. Correct any worn or damaged parts […]

[Read more →]

FRONT OF VEHICLE – DISASSEMBLY AND ASSEMBLY
1. Park vehicle on level, hard (concrete) surface.
2. Block the rear wheels of the vehicle to prevent vehicle from moving in either direction and set parking brake.
3. Remove the track bar bolt 30 mm (save for later use) on the driver side of the frame mount (Fig.1), and the […]

[Read more →]

THIS KIT INCLUDES LOCK NUTS WHICH REQUIRE TIGHTENING WITH A WRENCH AFTER BEING STARTED BY HAND.
1. As shown in photo one (1), place D-shaped poly-bushings onto straight areas of the bar on each side of center hump. After installing D-bushings onto bar, place U-plates on D-bushings.
2. Place U-bolts on axle tubes next to casting as […]

[Read more →]

Jack-it, Inc. strongly recommends this kit be installed by a professional mechanic. Installing this kit will not strengthen or reinforce the stock frame of the vehicle, nor will it increase rollover protection. This kit is designed to level the front end of the vehicle in relation to the height of the rear end. We strongly […]

[Read more →]

The Auxiliary Idle Control Module, also called Auxiliary Powertrain Control Module (APCM), is for use in Light Trucks equipped with 7.3L DIT Diesel engines. Each kit includes an Auxiliary Idle Control module, wiring harness, mounting bracket and hardware, operator’s card, and this instruction booklet.
CHARGE PROTECTION
Charge Protection is used for maintaining battery charge. In Charge Protection […]

[Read more →]

Step 1: Prior to lifting the vehicle it is recommended that you measure the stock height of the vehicle so that you have a base line to gauge the height of the vehicle. Measure the vehicle from the bottom of the wheel to the lip of the fender. Position truck on a flat surface and […]

[Read more →]

Installation:
1. Secure and properly block the tires of vehicle on a level concrete or asphalt surface.
2. Open hood, remove the upper shock nuts and retainers, remove the 3 nuts on the upper shock tower brackets.
3. Jack up front of vehicle and install jack stands under frame behind the lower link rear brackets. Remove tires and […]

[Read more →]