- 1995-1999 Nissan Maxima Cattman Performance Cold Air Intake Installation Instructions Installation will take at least two hours. This could be done faster, but if you are removing the stock airbox and being very fastidious about the install, it is difficult
- 2005-2006 Nissan Frontier 4.0L V6 JBA Headers Installation Instructions Check to make sure you received the proper parts for your application. The header number will be stamped on the engine flange. If you are unsure you have received the
- 2004-2006 Nissan Maxima Bracketron Phone Mount Installation Instructions All instructions are written from the drivers seat position looking forward at the vehicle dash. We advise caution whenever your removing or handling plastic parts of a vehicles dash. Step. 1 Start by
- 1994 Ford Pickup F150 Spindle & Shaft Assembly Removal 1. Raise and support vehicle. Remove wheel assembly. Remove caliper from rotor. Remove locking hub. See AUTOMATIC LOCKING HUBS or MANUAL LOCKING HUBS under REMOVAL & INSTALLATION. 2. Remove wheel bearings, lock nuts,
- 05-09 V6 Ford Mustang dual exhaust system with Power-X crossover Installation instructions: 1.) Raise and support vehicle. 2.) Remove stock muffler from vehicle by un-bolting hangers from frame, loosening inlet clamp, and lowering unit out from under vehicle with hangers still attached
- 2004 Hyundai Santa Fe Timing & Counterbalance Shaft Belts Installation This application is an interference engine. Do not rotate camshaft or crankshaft when timing belt is removed, or engine damage may occur. Removal CAUTION: DO NOT rotate engine counterclockwise (as viewed from
- 01-06 Mitsubishi Montero/Galant Bracketron Phone Mount Installation Instructions Installation instructions for the Mitsubishi Montero - Locate and remove two vertical Phillips screws above the display panel. With Dash Trim Tool (#SIT-104), locate and release six (6) clips that secure
- 1995-2003 Nissan Maxima Stillen Rear Sway Bar Instructions Installation: 1. Establish the vehicle on flat ground. For easier installation lift rear of vehicle onto secure jack stands. 2. Remove rear wheels for ease of installation! 3. Remove the M6 screws that