- Victor Small-Block Ford Race Heads For Small Block Ford V8s Installation Instructions These heads require professional head preparation. #61099 - This Victor Small-Block Ford cylinder head is designed for ultra high-performance 302 and larger displacement Ford Windsor V8s. This head is based on
- Fitting Instructions KCA368 Application: Honda/Acura Civic, Integra, CR-V 2001-on. KCA368 is designed to replace the rear upper control arm-outer bushes on both sides of the car, and provides camber adjustment range of +/-0.75 degrees.
- 1933-1934 Ford Crossmember Kit Installation Instructions Remember the basic rule for a successful installation: 1. Start by supporting the car on 4 jack stands. The car should be sitting on approximately the same angle as it does
- 2005-2008 Nissan Xterra 4 X 4 2 Suspension Lift Kit Installation Instructions FRONT OF XTERRA 1. Park vehicle on level concrete surface. 2. Center and lock the steering wheel. 3. Block the rear wheels of the vehicle to prevent vehicle from moving in either direction. 4.
- Ford Five Hundred/Mercury Montego Direct Connect iPod Adapter Installation Guide You’ve purchased a Brandmotion iPod Adapter System designed, engineered, and built specifically for your Ford vehicle. We have made every effort to ensure that your Brandmotion iPod Adapter meets the
- Sirius Magnet-Mount Low Profile Antenna Kit Installation Instructions The instructions below are developed for BMW vehicles and are not be compared to any other existing instructions for vehicles other than BMW. No methods other than those specified in
- 2004-2006 Nissan Maxima SE/SL Cold Air Intake System Installation Instructions Removing the stock air inlet system a) Stock intake system. b) Free differential breather hose from inlet tube, if equipped. Use a supplied zip tie to secure the hose to the brake
- Dodge Vipers Harland Sharp Roller Rocker Arm Assembly and Installation Instructions We recommend fully reading the installation instructions before beginning. 1. Begin by installing the pushrod adjuster into the rocker arm. The cupped side faces down and is where the pushrod makes