- Vertical Door Kits Installation Instructions 1) Disconnect the battery. 2) Remove fender: Remove all Phillip’s screws or fasteners from the wheel well. Usually you will have to remove bolts to loosen the bumper Remove all bolts from
- 2005-09 Ford Mustang Rear Decklid Spoiler Kit Installation Instructions Perform this installation on a good clean level surface for maximum safety and with the engine turned off. Paint Preparation 1. Wipe each part with plastic prep (Dupont® 2319 or equivalent) 2. Wipe
- 2000-2003 Dodge Dakota Club cab 3.9L / 4.7L 2/4wd JBA Exhaust Installation Instructions TO START: 1. Remove and inventory JBA exhaust. 2. Disconnect negative battery cable and allow vehicle exhaust to cool. 3. With the vehicle raised and properly supported, spray lubricant on all rubber isolators.
- Ford Bracket #3342 SuperRail Installation Instructions The SuperGlide’s Way tubes are coated with SlipPlate at the factory to provide lubrication for ONE TRIP ONLY. The end user will need to continue using the graphite-based lubricant SlipPlate
- 2000-2004 Ford F-250/350 Superduty Wheel Drive Coil Over Convertion System LIFT INSTRUCTIONS: 1. Disconnect the negative terminal on the battery. Jack up the front end of the truck and support the frame, at the front frame rails, with jack stands. NEVER
- Alfa Romeo 8C The limited edition Alfa Romeo 8C is based on a shortened Maserati Coupe platform; it will be produced in a total of 500 cars, already totally sold out. The car
- 2004-2006 Nissan Maxima SE/SL Cold Air Intake System Installation Instructions Removing the stock air inlet system a) Stock intake system. b) Free differential breather hose from inlet tube, if equipped. Use a supplied zip tie to secure the hose to the brake
- 2008 Dodge Viper V10-8.4L Cold Air Intake Installation Instructions 1. Turn off the ignition and disconnect the negative battery cable. NOTE: Disconnecting the negative battery cable erases pre-programmed electronic memories. Write down all memory settings before disconnecting the negative