Automotive Manual, Car Parts and News

1. Start by supporting the truck on 4 jack stands. The truck should be sitting at approximately the same angle
as it does on the ground or slightly lower in front.
2. Remove all the old suspension components from the frame. The front spring shackle mounts riveted in the
frame are used for a measuring point. The top […]

[Read more →]

Read The Snowplow Operators Manual Before Assembling This Kit.
1. Remove the front bumper from the truck by first detaching four plastic trim panel retainers from the blocker beam crossmember and disconnecting the engine block heater cord and fog light connectors, if equipped. Trim panel retainers will be reinstalled later. Unbolt six fasteners to remove the […]

[Read more →]

INSTALLATION STEPS
1. Jack up the front of the truck and support the frame rails with jack stands. The tool list is on the back page. NEVER WORK UNDER AN UNSUPPORTED VEHICLE.
2. Starting on the passenger side of the truck remove the front tire. Remove the brake calipers from the spindle bracket using a 13 mm […]

[Read more →]

1. Start by supporting the truck on 4 jack stands. The truck should be sitting on approximately the same angle as it does on the ground, or slightly lower in front.
2. Remove all the old front suspension components, including the leaf springs and the engine mounting rails. Also remove the spring perches from the frame […]

[Read more →]

The recommended push beam height for this undercarriage assembly is 12-1/2″ from the center of the push beam to level ground. DO NOT exceed 14-1/2″ in height for this undercarriage.
WARNING: Always perform vehicle undercarriage installations with the keys removed from the vehicle’s ignition. Properly tag the ignition switch to alert others work is being performed […]

[Read more →]

This air bag system was designed around a stock exhaust configuration. Some aftermarket exhaust systems will require modifications to the tail pipe!
• We recommend installation be done by a trained professional.
• Read instructions carefully before attempting installation.
• Secure and properly block vehicle prior to installation.
NOTE: Installation will be done with rear axle at full droop […]

[Read more →]

The mounting procedure outlined below covers 1992 – 1996 FORD F150 trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as follows:
1. Remove the front bumper. If the truck is equipped with a front stabilizer bar, remove […]

[Read more →]

1. Start your installation by supporting the truck on 4 jack stands. The truck should be sitting on the approximate angle that it does on the ground, or slightly lower in front.
2. Begin by removing all the stock suspension components from the frame. The front crossmember should be left in place.
3. Boxing the rails is […]

[Read more →]

Each lift kit, and options to lift kits, are packaged separately. Therefore installation procedures are covered in separate instructions. Familiarize yourself with each specific set of instructions before beginning.
INTRODUCTION
• Installation by a professional mechanic is recommended. Use of the appropriate tools, a Dodge service manual, and a shop hoist can greatly reduce installation time.

[Read more →]

The mounting procedure outlined below covers 1994 & newer 4 X 4 DODGE ū and 1 ton and 1994 - 1996 4 X 4 DODGE ― ton trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as […]

[Read more →]