Automotive Manual, Car Parts and News

Tools required: - Vehicle ramp or Jack and axle stands, T25 Torx driver, T30 Torx driver, 8mm spanner, 10mm socket, ratchet and extension bar, Pozzidrive screwdriver, Flat blade screwdriver, Trim removal type tool, Protective clothing, footwear and eyewear are also recommended.
1. Raise the vehicle on a ramp or place on axle stands. Open bonnet. Remove […]

[Read more →]

1. Turn off the ignition and disconnect the negative battery cable.
2. Disconnect mass air sensor electrical connection.
3. Rotate crank case vent hose locking ring and pull crank case vent hose off of air filter housing. Un-hook wiring harness retaining clip from air box.
3a. Disconnect the brake booster vent line from the air filter housing as […]

[Read more →]

1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm socket.
5. Remove the oil filler cap (for clearance if needed) and […]

[Read more →]

PowerAid Throttle Body Spacer Installation Instructions for 03-08 Dodge Ram 5.7L Hemi
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm […]

[Read more →]

STEP 1. Open up the power outlet door and locate and remove one (1) Phillips head screw using your # 2 Phillips screwdriver . Set screw aside. Open up both the cup holder door and the ashtray door. Remove the dash trim bezel that surrounds the radio and climate control and extends across the instrument […]

[Read more →]

Do not attempt to manually extend or retract the mirrors. They should be moved under their motor power only!
Tools required for the installation are: 10mm deep socket, a 10mm open end wrench, trim panel remover, Philips screwdriver, razor knife, and torque inch pound wrench. For model 7005TK, a volt meter will be necessary. If you […]

[Read more →]

The front fascia and tie down brackets are removed for baseplate installation. Tie down brackets will not be reinstalled. No drilling necessary. The BX8869 is available for the vehicle. Attachment Tabs are 22 inches center to center and a height of 15 5/8 inches.
1. Remove two phillips screws from under fascia corner, just forward of […]

[Read more →]

1) Disconnect the battery.
2) Open door completely and loosen the door catch that is attached to the inner frame and the door. Later we’ll remove it.
3) Remove fender:
Remove all 6 screws that are attached to the inner fender well.
Remove (2) 10mm bolts that secure the bumper to the fender.
After removing the (2) 10mm bolts you […]

[Read more →]

1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the mass air sensor electrical connection.
3. Loosen the hose clamps on the intake hose at the throttle body and mass air sensor.
4. Using a 10mm socket, loosen and remove the bolt that holds the vacuum switch to the airbox lid.
5. Release the […]

[Read more →]

The front fascia, lower grill, and tie down brackets are removed for baseplate installation. Lower grill will need to be trimmed or left out. Tie down brackets will not be reinstalled. No holes need to be drilled. The BX8869 is available for the vehicle. Attachment Tabs are 20 inches center to center and a height […]

[Read more →]