Automotive Manual, Car Parts and News

RSS Feed

Free PDF Download, Car Parts and Automotive News

How does the 1953 Chevrolet Pick-Up Truck Run?

January 5th, 2011 · No Comments

I’m aware that it’s the car from Twilight, but believe it or not that’s NOT why I like it. I need a relatively reliable car to get me around, but I’m really into this truck. Is it had to maintain? Will it last? Is it reliable? How much does it usually cost?
I’m know close to [...]

[Read more →]


Dodge Sprinter 2007-2008 XSVI-1784-NAV Installation Instructions

December 10th, 2010 · No Comments

In the Dodge vehicle listed above there are no 12 volt accessory wires currently in the factory harness making the installer run an accessory wire to the fuse box or underneath the steering column when installing an aftermarket radio. The XSVI-1784-NAV is designed to provide a 12 volt 10 amp switched accessory output along with [...]

[Read more →]


Ready Remote Model 24927 Owner’s/Installation Guide

September 28th, 2010 · No Comments

This system will allow convenient access to your vehicle with the push of a button, as well as remote start and other optional features. Properly installed, this system will provide years of trouble-free operation. Please take the time to carefully read this User’s Guide in its entirety and watch the READY REMOTE Do-It-Yourself Installation Video [...]

[Read more →]


Auto Meter Tach Adapter Installation Instructions

September 18th, 2010 · No Comments

Installation
The Auto Meter Tach Adapter wires inline on the positive 12 volt supply wire. It senses current on the coil positive wire and converts it to a 12 volt signal output. To install the Tach Adapter, the coil positive wire must be identified for your application. Once the wire has been located it is recommended [...]

[Read more →]


Fuel Cut Defender Type II Instructions

November 5th, 2009 · No Comments

Before installing the Fuel Cut Defender it is important to determine were the vehicles ECU receives its boost reference signal from the manifold absolute pressure sensor or air flow meter, failure to connect the boost cut defender to the correct sensor could cause severe engine damage. It is advisable to consult the manufacturer service manuals [...]

[Read more →]


Electric Brake Actuator Kit Service Manual

September 28th, 2009 · No Comments

The Carlisle trailer brake actuator is a microprocessor-based 12 Volt DC system for use on single, two, and three axle trailers equipped with electric brakes. The CARLISLE actuator kit consists of a trailer mounted actuator, a “deep cycle”, 17 amp-hour trailer brake battery, an emergency breakaway switch, and an in-cab controller.

[Read more →]


Hydraulic Disc Brake System with the ActiBrake Actuator Installation

September 27th, 2009 · No Comments

ActiBrake is part of a trailer braking system. For this system to be complete, you also need the following components:
• In-cab brake controller
• A reliable, fully charged 12 volt breakaway battery
• Breakaway switch
• Trailer connector – wiring harness paired with a matching tow vehicle connector, properly wired to the tow vehicle
• A reliable, fully charged [...]

[Read more →]




?>