I need to get all the air out of the system. Because I tried to keep the cooling level full and letting it warm up to operating temp with the radiator cap off and that does not work there is still air in there. do i need to disconnect any hoses or anything like that.
January 5th, 2011 · No Comments
January 4th, 2011 · No Comments
I changed the plugs and the wires were kinda old and now there is a miss-fire.I need to change the plug wires but they kinda dissappear under the intake.
January 1st, 2011 · No Comments
I have a 2.2l ohv 2001 cavalier and i am trying to take the heads off but there seems to be alot of things involved will somebody let me know the steps to removing them maybe like if you have alldata i do not have a subscription.
December 31st, 2010 · No Comments
I have a 2003 Chevrolet Trailblazer. V6 4.2L. When I turn on the Air Conditioner this foul smell comes out at first but then goes away when it starts to circulate. I know this truck doesn’t have a cabin air filter so any idea what could be the problem and any idea on how to [...]
December 29th, 2010 · No Comments
This Borla Performance Cat-back™ Exhaust System (Part number 140280, 140281) has been designed for 2010 Chevrolet Camaro equipped with a 6.2L V-8 engine and automatic or manual transmissions. Borla Performance Cat-back™ Exhaust System (part number 140282) has been designed for 2010 Chevrolet Camaro equipped with a 3.6L V-6 engine with an automatic or manual transmission.
June 5th, 2010 · No Comments
The first member of the current Audi V family of engines was the 3.2-liter V6 FSI engine. Special features of the Audi V-engine family are the 90-degree angle between the cylinder banks and the 90 mm spacing between the cylinders. The 4.2-liter V8 FSI engine is also a member of this family. It is available [...]
May 16th, 2010 · No Comments
If you receive customer reports in the above model vehicles of the front or rear seat belts
not rolling up fully, the cause could be dirt deposits on the seat belt guide due to a soiled
seat belt. Cleaning the belt guide and seat belt should restore proper function of the seat
belt retraction. To resolve, perform the [...]
September 24th, 2009 · No Comments
Installation of the AEM Short Ram Intake System.
a) When installing the Short Ram Intake System, DO NOT completely tighten the hose clamps or mounting tab hardware until instructed to do so later in these instructions.
b. Install the supplied 1.75” to 2.25” reducing elbow onto turbo inlet with pipe and clamps as shown.
c. Assemble the supplied [...]