Automotive Manual, Car Parts and News

GENERAL NOTES:
1. THIS SYSTEM SHOULD ONLY BE INSTALLED BY A PROFESSIONAL MECHANIC.
2. Compare all contents of the boxes to the parts list before starting to insure all components are included.
3. Prior to installing the suspension system, inspect the vehicle’s suspension components, alignment, and frame for damage, corrosion, or cracks. Correct any worn or damaged parts […]

[Read more →]

When assembling the transmission to the transfer case, DO NOT FORCE the two gear boxes together. If the shaft is too long, there is the possibility of pre-loading the transmission bearings for premature failure. Take the extra time to make sure that the shafts do not bottom out internally. If there is an interference problem, […]

[Read more →]

Step 1: Prior to lifting the vehicle it is recommended that you measure the stock height so that you have a base line measurement. Measure from the bottom of the wheel to the lip of the fender, as in Insert A. Position truck on a flat surface and lift vehicle by the frame so that […]

[Read more →]

Installation by a trained mechanic is recommended
Step 1: Position vehicle on a flat surface and lift vehicle by the frame so that the front wheels are off the ground. Use a floor jack and jack stands or a (2) two post lift if available. Next, locate the torsion key at the rear of the torsion […]

[Read more →]

Step 1: (A) Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground using a floor jack and jack stands or a (2) two post lift if available. Next locate the torsion key at the rear of the torsion bar under the cab of […]

[Read more →]

Step 1: Position truck on a flat surface and lift the front wheels off the ground using jack stands or a (2) two post lift if available. Remove the wheels and tires on both sides. Remove the two lower sway bar nuts on both sides of truck. (Insert A) Remove the driver’s side cotter pin […]

[Read more →]

Step 1:
Position truck on a flat surface and lift the front wheels off the ground using jack stands or a (2) two post lift if available. Remove the wheels and tires on both sides. Remove the two lower sway bar nuts on both sides of truck. (Insert A)
Remove the driver’s side cotter pin and loosen […]

[Read more →]

1. INSPECT SHOE LINING THICKNESS
Remove the inspection hole plug, and check the shoe lining thickness through the hole. If less than the minimum, replace the shoes. Minimum thickness: 1.0 mm (0.039 in.)
2. REMOVE REAR WHEEL
3. RELEASE PARKING BRAKE LEVER
4. REMOVE BRAKE DRUM
HINT:
If the brake drum cannot be removed easily, do the following steps.
(a) Remove the […]

[Read more →]