This Borla Performance X-Pipe (Part number 60089) has been designed for 2005-2008 Chevrolet Corvette C6 equipped with a 5.7L V-8 engine and automatic transmission or manual transmissions. Borla Performance Industries recommends that an exhaust shop or professional after market parts installer, who has all the necessary equipment, tools and experienced personnel needed for proper […]
2005-2008 Chevrolet Corvette X-Pipe Installation
September 1st, 2010 · No Comments
2003-08 Dodge Ram 1500/2500/3500 V8-5.7L Hemi Kit 77-1533 Instructions
January 5th, 2010 · No Comments
1. Turn off the ignition and disconnect the negative battery cable.
2. Loosen the hose clamp at the intake resonator as shown.
NOTE: Disconnecting the negative battery cable erases pre-programmed electronic memories. Write down all memory settings before disconnecting the negative battery cable. Some radios will require an anti-theft coded to be entered after the battery is […]
03-05 Dodge Ram 5.7L Hemi PowerAid Throttle Body Spacer Installation Instructions
January 3rd, 2010 · No Comments
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm socket.
5. Remove the oil filler cap (for clearance if needed) and […]
2000-2003 Dodge Dakota Club cab 3.9L / 4.7L 2/4wd JBA Exhaust Installation Instructions
December 15th, 2009 · No Comments
TO START:
1. Remove and inventory JBA exhaust.
2. Disconnect negative battery cable and allow vehicle exhaust to cool.
3. With the vehicle raised and properly supported, spray lubricant on all rubber isolators. Using the pry bar, remove rubber isolators from muffler hangers.
4. Remove the factory exhaust clamp located directly behind the catalytic converter.
5. Remove the tail pipe […]
2007.5 Dodge Ram Cummins L6-6.7L Intake kit Installation Instructions
December 12th, 2009 · No Comments
- Complete Stock Intake.
- With 5/16” nut driver loosen clamps on OE tube at turbo/air box and remove. Loosen clamp at turbo and disconnect crank case line with pliers. Remove tube.
- Disconnect air temp & MAF sensor. Loosen 10mm nut holding in front of air box using wrench or socket. Lift up and pull OE […]
03-08 Dodge Ram 5.7L Hemi PowerAid Throttle Body Spacer Installation
November 27th, 2009 · No Comments
PowerAid Throttle Body Spacer Installation Instructions for 03-08 Dodge Ram 5.7L Hemi
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm […]
