Installation Instructions: Solid Bench Seat
Step One: Tilt the back of the rear seat forward. Remove jack handles from current plastic tray (if applicable). Using an 8mm socket remove bolts holding current plastic tray. Remove tray from truck. If you experience problems removing bolts you may need to apply upward pressure from under tray.
Step Two: Set […]
2000-2006 Ford F250 thru F550 Super Duty Crew Cab & Regular Cab Installation
January 26th, 2010 · No Comments
03-05 Dodge Ram 5.7L Hemi PowerAid Throttle Body Spacer Installation Instructions
January 3rd, 2010 · No Comments
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm socket.
5. Remove the oil filler cap (for clearance if needed) and […]
1992-96 Dodge Stealth Pro.Fit VSM Kit Installation Instructions
November 29th, 2009 · No Comments
STEP 1. Begin by opening the armrest door. Using the Phillips screw-driver, locate and remove two (2) Phillips screws inside and toward the back of the armrest storage compartment. Set screws aside. Just in front of the armrest locate a small plastic cap. Using the small flat screw-driver carefully pry cap loose exposing two (2) […]
03-08 Dodge Ram 5.7L Hemi PowerAid Throttle Body Spacer Installation
November 27th, 2009 · No Comments
PowerAid Throttle Body Spacer Installation Instructions for 03-08 Dodge Ram 5.7L Hemi
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm […]
2004-up Mazda Speed 3 Base Bushing Installation Manual
November 6th, 2009 · No Comments
1. Unscrew the stock shift knob by rotating it counter clockwise.
2. Open the storage compartment in the center console and remove the foam rubber mat in the bottom to access the 2 bolts. Use an 8mm socket and ratchet with an extension to remove the 2 bolts.
3. Lift up on the rear half of the […]
2002 Mazda Protege XL BX2517 Installation Instructions
October 25th, 2009 · No Comments
The front fascia, lower grill, and tie down brackets are removed for baseplate installation. Lower grill will need to be trimmed or left out. Tie down brackets will not be reinstalled. No holes need to be drilled. The BX8869 is available for the vehicle. Attachment Tabs are 20 inches center to center and a height […]