Automotive Manual, Car Parts and News

The following information describes the installation procedure for the M-11572-GT “ENGINE START” push-button
into a 2005-‘09 Mustang.
STEP 1: Start by removing the (2) screws found at the rear of the center console underneath the armrest.
STEP 2: Remove the trim plate which surrounds the Shifter Handle (Auto) or Shifter Boot (Manual).
Note: Manual transmission applications will require removing […]

[Read more →]

Step 1: Prior to lifting the vehicle it is recommended that you measure the stock height of the vehicle so that you have a base line to gauge the height of the vehicle. Measure the vehicle from the bottom of the wheel to the lip of the fender. Position truck on a flat surface and […]

[Read more →]

PRE-INSTALLATION NOTES
1. Special literature required: OE Service Manual for model/year of vehicle. Refer to manual for proper disassembly/reassembly procedures of OE and related components.
2. Adhere to recommendations when replacement fasteners, retainers and keepers are called out in the OE manual.
3. Larger rim and tire combinations may increase leverage on suspension, steering, and related components. When […]

[Read more →]

Step 1: Prior to lifting the vehicle it is recommended that you measure the stock height so that you have a base line measurement. Measure from the bottom of the wheel to the lip of the fender, as in Insert A. Position truck on a flat surface and lift vehicle by the frame so that […]

[Read more →]

FITTING YOUR BOV 300ZX ADAPTOR
Note: Please thoroughly read and understand both these instructions and the fitting instructions supplied with your BOV before commencing this installation.
Step 1. Locate the two boost hoses.
Step 2. Loosen the factory hose clamps securing the boost hoses to the intercooler pipe and throttle body.
Step 3. Loosen the factory hose clamps securing […]

[Read more →]