Automotive Manual, Car Parts and News

RSS Feed

Free PDF Download, Car Parts and Automotive News

How to put an air bag on 97 Chevrolet Cavalier?

January 7th, 2011 · No Comments

I need to hook up the horn to the steering column
- You don’t, unless you really know what you are doing. Most garages won’t do it either, it is too easy to set the air bag off if you don’tknow what you are doing.

[Read more →]


Chevrolet Ford Dodge Transmission Removal, Installation and Testing

December 29th, 2010 · No Comments

Applicable for Chevrolet LCT1000–LCT2500, Ford 47RH / 47RE / 48RE, Dodge E4OD / 4R100
Removal NOTE: Check and record all codes and actions of your transmission before transmission is removed. This will help if you still have problems after installation. Damage to your transmission may have been caused from some other external source.
Deactivate air bag system [...]

[Read more →]


How do I get Nissan to cover an airbag light?

December 21st, 2010 · No Comments

It is a 2001 Maxima- this is a safety issue. I am well over on the miles but out of the blue, the light is flashing- mechanic said it likely needs a module that costs about $900.

[Read more →]


SoundGate CANPULSE4 Interface Instructions

November 3rd, 2010 · No Comments

The CANPULSE4 interface is a multi-function interface (plug and play cable included) that performs the following functions: Ignition output (1 amp maximum supply), Illumination output (1 amp maximum supply), Speed sense wire, Mute output, and Reverse. CANPULSE4 can also serve as a Steering wheel control interface (in vehicles so equipped with steering wheel mounted audio [...]

[Read more →]


Honda/Kia/Hyundai Electronic Cruise Kit Part Number: 250-1859

October 11th, 2010 · No Comments

Pre-Installation Suggestions
1. It is advisable to disconnect the negative battery cable for 3 minutes before beginning installation, to avoid unintended air bag deployment. Note and record any anti-theft radio codes prior to disconnecting.
2. Remove the driver side lower dash and kick panels. Remove the steering wheel shroud.
Install Electronic Module
1. Plug in the Main Wiring Harness, [...]

[Read more →]


Viper Model 130XV Installation Guide

September 28th, 2010 · No Comments

Before beginning the installation:
- Please read this entire installation guide before beginning the installation. The installation of this remote start system requires interfacing with many of the vehicle’s systems. Many new vehicles use low-voltage or multiplexed systems that can be damaged by low resistance testing devices, such as test lights and logic probes (computer safe [...]

[Read more →]


2006-2007 Ford F-53 Chassis Motorcoach Front Installation Instructions

March 3rd, 2010 · No Comments

Installation
1. Place the coach on a level concrete surface. Measure each side of the coach from the front wheel well to the ground. Record these measurements as you will need them in Step 9.
2. Place a jack under each side of the frame just behind the leaf spring shackles. Jack the coach up high enough [...]

[Read more →]


Ford Long Travel Air Bag Instructions

February 18th, 2010 · No Comments

This air bag system was designed around a stock exhaust configuration. Some aftermarket exhaust systems will require modifications to the tail pipe!
• We recommend installation be done by a trained professional.
• Read instructions carefully before attempting installation.
• Secure and properly block vehicle prior to installation.
NOTE: Installation will be done with rear axle at full droop [...]

[Read more →]


2003-Up Dodge 2-bag Rear System Install Instructions

December 20th, 2009 · No Comments

Before installation of the Air Ride unit, prepare a smooth, flat, hard surface and have all tools and equipment needed for the job. Chock the front wheels of the truck, to prevent it from rolling forward or rearward. Place a jack on each side of frame ahead of the rear springs, front bolts.

[Read more →]


2005 Dodge Dakota 2″ Coil Spring Leveling Kit Installation Instructions

December 15th, 2009 · No Comments

This coil spring lift kit should only be installed on vehi- cles in good working condition. Before installation, the vehicle should be thoroughly inspected for evidence of corrosion or deformation. This coil lift kit should not be installed on any vehicle that is suspected to have been in a collision or misused. Failure to observe [...]

[Read more →]




?>