Automotive Manual, Car Parts and News

Toyota Corolla 1.6L 16v 116bhp (4A-FE Engine) 1992 – 1997
Disconnect the negative battery terminal from the battery. Carefully disconnect & remove the air temperature sensor from the air box lid. (Fig. 1) Unclip and remove the intake hose from the throttle housing. Unclip and remove the air box lid assembly from the vehicle. Unscrew and […]

[Read more →]

It is preferable to park on a flat surface, as you will have to engage and disengage the hand brake and shift from gears to neutral. If you cannot do so and are obliged to install the shifter cable bushings on a slightly inclined surface, place wooden blocks in front or behind the wheels to […]

[Read more →]

In order to accommodate the cyclone air filter, the snorkel must sit forward of the “A” pillar on the vehicle. This is to avoid interference between the “A” pillar and the cyclone air cleaner.
Detailed Instructions
1 Remove the left hand side inner guard. Remove the plastic inner guard insert by removing the plastic clips. Refer to […]

[Read more →]

This kit requires the removal and reinstallation of emissions related components. If you are not familiar with the removal / installation and/or the operation of these components then please refer this installation to a qualified professional.
1) Getting started
a) Make sure vehicle is parked on a level surface.
b) Set parking brake.
c) Disconnect both positive and negative […]

[Read more →]

Please review complete instructions prior to installing.
Step of Installation:
1. Verify you have all of the following parts included in the kit: (1) JLT painted pipe with IAT and PCV fittings, (1) Rubber Reducer with Clamps, (1) Rubber coupler, (2) #56 Clamps, (1) 4×12” Oval Air Filter, (1) MAF Adaptor with bolts, (1) Wire Harness Extension […]

[Read more →]

You have just purchased the best engineered and most advanced air intake system, equiped with Ea nanofiber air filter. Please check the contents of this box immediately. Report any defective or missing parts to the authorized Injen or AMSOIL dealer you purchased this product from. Before installing any parts of this system, please read the […]

[Read more →]

On this particular model vehicle, there is not splashguard underneath the vehicle. This means that the air filter is exposed to the outside elements. Extreme care must be taken while driving the vehicle in the rain. If you have to traverse any deep water, do so with extreme caution. If rains are intense, it may […]

[Read more →]

- Complete Stock Intake.
- With 5/16” nut driver loosen clamps on OE tube at turbo/air box and remove. Loosen clamp at turbo and disconnect crank case line with pliers. Remove tube.
- Disconnect air temp & MAF sensor. Loosen 10mm nut holding in front of air box using wrench or socket. Lift up and pull OE […]

[Read more →]

Remove air cleaner assembly.
a) Disconnect air tube from air box.
b) Remove air box lid and filter.
c) Remove air cleaner assembly from fender. Loosen nut at rear near washer reservoir. Remove plastic stud from filter box snout, then remove assembly from vehicle.

[Read more →]

Dodge Caliber, Jeep Compass Subwoofer Installation
1. Lift up on the B pillar post cover and then pull it towards the center of the car to remove.
2. Using a panel removal tool gently pry up the threshold/kick panel along the bottom of the front and rear door openings to release fasteners and remove panel.
3. Find the […]

[Read more →]