Automotive Manual, Car Parts and News

Parts Needed: New Crank pulley Bolt (Ford part # F5RZ-6A340-B)
1: Verify that your kit has all the parts included. The kit comes complete with a smaller iron crank pulley, an oversized water pump pulley, and the instructions.
2: Remove the air intake, this step isn’t required but makes for a much easier installation when you are […]

[Read more →]

1. Turn off the ignition and disconnect the negative battery cable.
2. Loosen the hose clamp at the intake resonator as shown.
NOTE: Disconnecting the negative battery cable erases pre-programmed electronic memories. Write down all memory settings before disconnecting the negative battery cable. Some radios will require an anti-theft coded to be entered after the battery is […]

[Read more →]

List of tools and additional parts required
Masking tape, clear tape, black mastic, hammer, centre punch
Assorted screw drivers, sockets and spanners 103mm (4”) hole saw
Assorted drill set, wet / dry sand paper, ½ round file, small square file, Zinc rich primer.

[Read more →]

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the air temp. sensor electrical connection.
3. Loosen the hose clamps at the turbo inlet and the airbox outlet as shown.
4. Remove the intake tube from the vehicle as shown.
5. Loosen and remove the 10mm nut that retains the airbox to the […]

[Read more →]

The front fascia and tie down brackets are removed for baseplate installation. Tie down brackets will not be reinstalled. No drilling necessary. The BX8869 is available for the vehicle. Attachment Tabs are 22 inches center to center and a height of 15 5/8 inches.
1. Remove two phillips screws from under fascia corner, just forward of […]

[Read more →]

PowerAid throttle Body spacer instruction for Nissan Xterra/Frontier:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake assembly.
3. Remove (4) bolts from the throttle body. (Ref. “C”)
4. Remove gasket and clean surfaces.
5. Remove bolts from the throttle linkage bracket and save.

[Read more →]

1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the mass air sensor electrical connection.
3. Loosen the hose clamps on the intake hose at the throttle body and mass air sensor.
4. Using a 10mm socket, loosen and remove the bolt that holds the vacuum switch to the airbox lid.
5. Release the […]

[Read more →]

A musty/mildew type odor may come from the vents when the air conditioning (A/C) system is operating. It is most noticeable when the A/C is first turned ON. This odor is the result of mold growth in the A/C evaporator/ cooling unit which is caused by condensation, dust, and pollen within the cooling unit. This […]

[Read more →]

CLiMAtE ControL & Air ConDitioning
A Temperature Control Dial
Turn the dial clockwise/counterclockwise to make the air warmer/ cooler.
B Air Conditioning Switch
Press the button to turn on/off the A/C.
C Blower Fan Speed Control Dial
Turn the dial clockwise/counterclockwise to increase/ decrease the fan speed.

[Read more →]

Congratulations! You have purchased the finest street Supercharger available for the 2002 5.9L Dodge Ram 1500. The centerpiece of this kit is the highly efficient and reliable Paxton Automotive Corp. NOVI-2000 supercharger. A mechanically driven (by belt) centrifugal blower (supercharger). This kit comes with all of the parts you’ll need for a successful installation. The […]

[Read more →]