Automotive Manual, Car Parts and News

Removing the stock air intake system
a) Loosen the hose clamps attaching the primary stock intake pipe to the throttle body and the primary stock intake pipe to the mass air flow sensor.
i) Remove the primary stock intake pipe.
b) Disconnect the wiring harness from the mass air flow sensor.
c) Remove the sensor from the stock intake […]

[Read more →]

You have just purchased the best engineered and most advanced air intake system, equiped with Ea nanofiber air filter. Please check the contents of this box immediately. Report any defective or missing parts to the authorized Injen or AMSOIL dealer you purchased this product from. Before installing any parts of this system, please read the […]

[Read more →]

1. Disconnect the negative battery cable, and remove the factory “accordion” style intake hose by loosening the two factory clamps.
2. Loosen the two 10mm bolts securing the factory air box to the intake manifold.
3. Disconnect the air temperature sensor wire on the front of the factory air box & twist to remove the sensor from […]

[Read more →]

Remove air cleaner assembly.
a) Disconnect air tube from air box.
b) Remove air box lid and filter.
c) Remove air cleaner assembly from fender. Loosen nut at rear near washer reservoir. Remove plastic stud from filter box snout, then remove assembly from vehicle.

[Read more →]

This inlet pipe kit requires the removal and reinstallation of emissions related components. If you are not familiar with the installation and/or the operation of these components then please refer this installation to a qualified professional.
Installing the Short Ram Air Intake System
a) When installing the AEM Air Intake System, DO NOT completely tighten the hose […]

[Read more →]

Installing the Short Ram Air Intake System
a) When installing the Short Ram Air Intake System, DO NOT completely tighten the hose clamps or mounting tab hardware until instructed to do so later in these instructions.
b) Check to see that the inside of the AEM inlet pipe and air filter are clean and free from any […]

[Read more →]

Disconnect the negative battery terminal before starting this installation.
1. Remove the air intake duct, the air intake box and the air vacuum lines connected to the air box. Unbolt the air mass sensor from the air box and set aside at this point. This installation also requires removal of the front bumper and the air […]

[Read more →]

Loosen the clip securing the Remove the air box mounting screw air box to the throttle body underneath the air box.
Unclip and remove the breather pipe from the cam cover
Remove the two nuts and two screws from the metal shield attached to the front panel. Remove the sheild.
Fit the rubber breather hose approximately 2cm into […]

[Read more →]

Removal of the Stock Air Intake System
a) Remove the three plastic fasteners that secure the air scoop. And remove it.
b) Remove the bolt securing the connector tube to the chassis, loosen the hose clamps as shown, and remove the connector tube assembly.
c) Loosen the indicated bolt, unplug the MAF connector, and remove the air filter […]

[Read more →]

This inlet pipe kit may require the removal and reinstallation of emissions related components. If you are not familiar with the installation and/or the operation of these components then please refer this installation to a qualified professional.
Removing the stock air inlet system
a) Remove the bolts and nut holding the strut tower bar in place. Unclip […]

[Read more →]