Automotive Manual, Car Parts and News

1. Turn off the ignition and disconnect the negative battery cable.
2. Loosen the hose clamp at the intake resonator as shown.
NOTE: Disconnecting the negative battery cable erases pre-programmed electronic memories. Write down all memory settings before disconnecting the negative battery cable. Some radios will require an anti-theft coded to be entered after the battery is […]

[Read more →]

1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm socket.
5. Remove the oil filler cap (for clearance if needed) and […]

[Read more →]

Removing the stock air inlet system:
a) Loosen the five screws securing the stock air box lid. Remove the air box lid from the vehicle.
b) Remove the Inlet Air Temperature (IAT) sensor. The metal band will need to be pried off with a flat-head screwdriver. Use care to avoid damaging the IAT sensor.
c) Remove the air […]

[Read more →]

To Start the installation:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Unlock the red locking tab on the air temperature sensor electrical connection, then depress the locking lever and pull apart the temperature sensor electrical connection
3. Loosen the hose clamp that secures the intake tube to the throttle body and pull […]

[Read more →]

Removing the stock air inlet system
a) Before removing any of the O.E. components, label each individual part so that no components become mixed up during the installation process.
b) Stock air system
c) Unplug the Inlet Air Temperature Sensor (IAT) from the stock resonator box
d) Remove the breather hose from the plastic tee (Vehicles equiped with plastic […]

[Read more →]

PowerAid Throttle Body Spacer Installation Instructions for 03-08 Dodge Ram 5.7L Hemi
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm […]

[Read more →]

- Loosen AFM clamp (1) securing the crossover tube (4) to the AFM
- Unplug the AFM connector (2) by pushing down on the tab and pulling away. Do not pull on the wires.
- Remove the three plastic clips securing the air temp sensor wire to the air box.
- Separate the crossover tube (4) from the […]

[Read more →]

The AEM Cold Air System is the result of extensive development on a wide variety of cars. Each system is engineered for the particular application. The AEM Cold Air System differs from all others in several ways. We take the inlet air from outside of the engine compartment where the inlet air is considerably cooler […]

[Read more →]