Automotive Manual, Car Parts and News

1. Start by disconnecting the wire harness from the MAF sensor as shown.
2. Next loosen the hose clamp that attaches the stock air tube to the stock air box as shown.
3. Remove the bolt that holds the stock air box in place and set aside for reuse with the MAC air system.
4. Next remove the […]

[Read more →]

1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm socket.
5. Remove the oil filler cap (for clearance if needed) and […]

[Read more →]

Remove air cleaner assembly.
a) Disconnect air tube from air box.
b) Remove air box lid and filter.
c) Remove air cleaner assembly from fender. Loosen nut at rear near washer reservoir. Remove plastic stud from filter box snout, then remove assembly from vehicle.

[Read more →]

PowerAid Throttle Body Spacer Installation Instructions for 03-08 Dodge Ram 5.7L Hemi
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm […]

[Read more →]

1) Remove Engine Cover
2) Disconnect Intake Air Tube from T
3) Unplug the Drive-By-Wire Throttle Body Connector
4) Unplug the blue EVAP solenoid connector and make sure it’s free from the UIM
5) Unbolt VIAS tank and solenoid from Upper Intake Manifold (UIM)

[Read more →]