Automotive Manual, Car Parts and News

RSS Feed

Free PDF Download, Car Parts and Automotive News


Ford Bracket #3342 SuperRail Installation Instructions

January 13th, 2010 · No Comments

The SuperGlide’s Way tubes are coated with SlipPlate at the factory to provide lubrication for ONE TRIP ONLY. The end user will need to continue using the graphite-based lubricant SlipPlate or a medium duty grease on the top and inward facing sides of the way tubes. See Owner’s Manual for complete lubrication instructions.

[Read more →]


2003 Dodge 1500 4WD 6″ Suspension Lift Installation Instructions

January 5th, 2010 · No Comments

FRONT :
1.With vehicle on flat level ground, set the emergency brake and block the rear tires. Place floor jack under the lower control arm’s front cross member and raise vehicle. Place jack stands under frame rails, behind the front wheel wells, then lower the frame onto the stands. Remove the factory skid plate.
2. Remove the […]

[Read more →]


Dodge Vipers Harland Sharp Roller Rocker Arm Assembly and Installation Instructions

December 5th, 2009 · No Comments

We recommend fully reading the installation instructions before beginning.
1. Begin by installing the pushrod adjuster into the rocker arm. The cupped side faces down and is where the pushrod makes contact. Screw the adjuster in until only the first thread is shown on the bottom side of the rocker arm.
2. Install the pushrod adjuster jam […]

[Read more →]


2004-2007 Nissan Titan & Armada 2WD & 4WD Strut Extension Kit Installation Instructions

November 21st, 2009 · No Comments

Step 1: Position truck on a flat surface and lift the front wheels off the ground using jack stands or a (2) two post lift if available. Remove the wheels and tires on both sides. Remove the two lower sway bar nuts on both sides of truck. (Insert A) Remove the driver’s side cotter pin […]

[Read more →]


2008-2009 Nissan Titan 2WD & 4WD ReadyLift Kit Installation Instructions

November 15th, 2009 · No Comments

Step 1:
Position truck on a flat surface and lift the front wheels off the ground using jack stands or a (2) two post lift if available. Remove the wheels and tires on both sides. Remove the two lower sway bar nuts on both sides of truck. (Insert A)
Remove the driver’s side cotter pin and loosen […]

[Read more →]


Camshaft Installation, Operation Instructions

November 3rd, 2009 · No Comments

These instructions are designed to give some basic information and things that you need to be aware of when attempting to install a camshaft in many overhead camshaft (OHC) and pushrod engines. For specific information and details on each individual engine and car combination, we recommend purchasing an owners repair manual, i.e., Haynes, Motor, Chilton, […]

[Read more →]